AOOTUYA A868 Modern Outdoor LED Wall Sconces Instruction Manual
- June 14, 2024
- AOOTUYA
Table of Contents
AOOTUYA A868 Modern Outdoor LED Wall Sconces
Product Overview
- Wall Light * 1
- Long Screw * 4
- Short Screw * 4
- Expansion Bolt * 4
- Installation Bracket *2
- Remote Controller * 1
- Product Manul * 1
Product Introduction
IP65 waterproof modern outdoor wall sconce can bring a full minimalist decorative effect to the house through simple installation, the color of the light can be easily adjusted through the equipped remote control, the minimalist style of the lines can be adapted to any decorative style, providing you with decorative as well as bright lighting effects.
Main Features
- Material : Iron & Acrylic
- Color Temperature ：3000K；4500K；6000K；
- Voltage : 85-265V
- Color : White Acrylic, Black Body
- Control method: Remote Control
- Product Brightness: Dimmable 10%-100%Waterproof
- Rating : IP65
- Installation : Hard-Wired
- LED Light Source: Low Energy Consumption
Remote Controller
When using the remote control to connect the light, press the setup button
twice within 5s, and the indicator light of the remote control will flash
twice which means successfully matched. Otherwise, please turn off the power
again and repeat the above actions.
Functions
-
Remote Control
Battery not included -
Memory Functions
After your next startup, the color of the last light is still retained -
Infinitely Dimmable
The lighting brightness can be adjusted between 10% -100% -
3 Light Colors
Warm light, Neutral light, Cool light -
IP65 Waterproof
Both the casing and built-in driver comply with IP65 waterproof rating -
Super Brightness & Anti Strobe
Installation Precautions
Note : Make sure the power is turned off.
-
Refer to step 1
Measure the distance between two mounting brackets on the product, then drill two holes on the wall with the same distance, and knock the expansion pipes into the holes. (warning: ensure that there are no gas, water, or power pipelines in the installation position of the drill) -
Refer to step 2
Fix the mounting bracket to the wall with the provided screws. -
Refer to step 3
Connect the neutral and live wires to the lamp.(no grounding wire is required. Do not fold the white signal receiving cable to avoid affecting the signal reception of the remote control. -
Fix the lamp body on the installation bracket with the provided screws, and shake the lamp body to check if it is completely fixed on the wall.
-
After checking for correctness, reconnect the power supply and complete the installation
After sales email: AOOTUYA@outlook.com
Matters Needing Attention:
- If the light flashes or alternates between light and dark during use, the most likely cause is voltage instability.
- The lighting brightness can start at a minimum of 10%, adjust the brightness to 5% each time, and reach a maximum of 100%.
- The product is externally connected with live and neutral wires, not with plugs. It is recommended to ask professional electricians for installation or reference this product manual for installation.
- Not support smart switch and dimmer switch, the brightness and color of the light will not produce any change.
ASSEMBLY INSTRUCTIONS
- Make a hole in the wall.
- Install the bottom frame.
- Install the lamp on the bottom frame.
- Fix the lamp to the base with the provided screws
- Done
If there are any product problems please contact AOOTUYA@outlook.com
Please read carefully before using the product to make it easier to install and use the product.