Phomemo D30 Label Maker Machine User Guide

Table of Contents

NOTE : The number of label rolls on the checklist is determined by the contents of the shipped package.

Name	Smart Mini Label Maker
Model	D30
Technology	Thermal Printing
Width of label	12-15mm
Supported Consumables	Black mark thermal Label, Pre-cut Label, Continuous

Parts and Features

Features of Continuous Labels

Phomemo -D30-Label-Maker-Machine-4

Gently bend the label along the east-to-tear line to tear the base from the adhesive easily

Indicator Light

Green Light	Normal
Blinking (slow) Green Light	Powered on & charging
Blinking (fast) Green Light	Powered oﬀ & charging

Error (No Paper, Cover is open,

Red Light| Overheat)
Blinking (slow) Red Light| 10% Power left
Blinking (fast) Red Light| 5% Power left

Open the label compartment.
Take out the label roll, tear the anti-loosening sticker.
place the label roll into the label compartment with the printing side facing left.
Pull out 5 mm of the label of the Label Maker
Close the cover.
Hold the power button for 3s to start the Label Maker
Press the power button once, and the Label Maker will start detecting the position of the label.01 Open the label compartment.
When the label comes out, the positioning of the label is complete.

NOTE :

After installing the label roll for the ﬁrst time or replacing the label roll, remember to reposition the label (Step No. 7 ).
If you do not reposition the label (Step No. 7 ), the ﬁrst label you print will be printed incorrectly (missing contents, not aligning to the center, etc.).
Continuous labels do not need repositioning. You only need to pull the label to the opening of the Label Maker.

Downloading the App

NOTE:

You need to connect the Label Maker through the Print Master app.
In compliance with Google’s requirement, Android phones must enable GPS (Location Services) before using Bluetooth.

Method 1:

Method 2:

Connecting the Label Maker

NOTE

In compliance with Google’s requirement, Android phones must enable GPS (Location Services) before using Bluetooth.
Before connecting to your device in Print Master, please make sure your Label Maker is turned on and your phone’s Bluetooth is on.

Method 1:
Check the anti-loosening sticker. (The label size shown below is just an example. The size of the label roll you have may vary.)
Meth od 2:
Check your label package
Method 3:
Measure with a ruler.
Method 4:
Check the tag on your label roll. (Label rolls are being updated, so the actual product you receive may vary.)

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed andused in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment oﬀ and on, the user isencouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit diﬀerent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

*RF warning for Portable device: