Gopher CPS-6011 60V DC Switching Power Supply User Manual

Gopher CPS-6011 60V DC Switching Power Supply

 Panel Layout

1. Volt Meter: Display the setting voltage or the actual output voltage
2. Current Meter: Display the setting current or the actual output current, or output state: OFF, OVP, OCP, OTP
3. Constant Voltage Indicator
4. Constant Current Indicator
5. Voltage/Current Select Switch:
6. V: adjust voltage
7. A: adjust current
8. Adjust Knob: Push to shift the digit
9. Output ON or OFF
10. LOCK or WATT
11. LOCK or WATT Indicator
12. Output Terminal: Red +, Black –
13. AC Power Switch
14. AC Power Socket
15. Operating Voltage Select Switch:
16. 115: Rated Input 100-120Vac
17. 230 : Rated Input 200-240Vac

 Function and Operation

1. Set Voltage
   Put the switch to “V”, click the adjusting knob to select adjust digit, and then adjust the knob to set the highlight digit.

2. Set Current
   Put the switch   to “A”, click the adjusting knob to select adjust digit, and then adjust the knob to set the highlight digit.

3. Turn on or turn off output
   when the output is turned off, the Amp Meter shows “OFF” ， press   , the output turns on, press the button again the output turns off.

4. Set the output ON at the AC power on
   Press for 5 seconds, Amp Meter shows “d On” for 2 seconds, the output turns on at the AC power on, go back to set the output turn off at AC Power on, press button for 5 seconds again, Amp Meter shows “d OFF”

5. Lock
   This function is configured on the model without suffix “ L”. Press  ，the lock light turns on , and adjusting knob are disabled. Press   again to cancel lock function.

6. Display the output power
   This function is configured on the model with suffix “ L ” . Press ， the power indicator turns on and Amp Meter displays the output power for 3 seconds

 Protection

1. Output short circuit protection
   When the output is short circuit, the power supply works on C.C mode, Amp Meter shows the short circuit current.

2. Over Voltage Protection
   Tracking over voltage protection, the OVP value is relevant to the setting voltage. When OVP is triggered, the output is shutdown, Amp Meter displays “OUP”, click to reset the OVP if the over voltage problem has been Q resolved.

3. Over Current Protection  resolved
   Tracking over current protection, the OCP value is relevant to the setting current. When the OCP is triggered, the output is shutdown, the Amp Meter display “OCP”, click . to reset the OCP if the over current problem has been resolved.

4. Over Temperature Protection
   The MCU monitor the temperature of the power supply, if the temperature is higher than the special value, the output is shut down; Amp Meter displays “OTP”, click is lower. button to reset the OTP if the temperature

Gopher Technology co, LIMITED Factory

• Add.: No. 71 Zhentian Bei Rd., Yantian, Fenggang Town, Dongguan, Guangdong, China
• Tel: +86-18145811687
• Email : gopherjiang123@gmail.com
• Web: http://www.gophertc.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>