RALPH LAUREN RL5722 Perren 10 Inch Pendant Light Instruction Manual

RALPH LAUREN RL5722 Perren 10 Inch Pendant Light

ASSEMBLY INSTRUCTIONS

Perren 10″ Pendant
Item # RL5722
NOTICE:
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED)

• Phillips Screwdriver
• Slotted Screwdriver
• Wire Cutters
• Wire Strippers

1. Carefully remove all parts from the box. Place on a clean, soft surface.

2. Remove mounting plate (B) from canopy (D) by removing collar ring (E).

3. Install mounting plate (B) to junction box and secure with mounting screws (C).

4. Thread glass shade (I) to fixture body (H).

5. Feed electrical and ground wires through bottom rod (G) and connect to fixture body (H).

6.  Continue feeding wires through collar ring (E), canopy (D) and top rod (F).

7. Holding fixture upright, slide collar ring (E) and canopy (D) down and rest on fixture body (H). Then connect top rod (F) to bottom rod (G). NOTE: Slide components down slowly to avoid damages.

8. Hang fixture swivel ball (J) to the center of mounting plate (B).

9. Cut excess wires, being sure to leave enough to reach the junction box.

10. Separate two sides of molded wire, and strip insulation on each 5/8″.

11. Connect fixture neutral wire (black) to the driver output neutral wire (black) using wire nut (A).

12. Connect fixture hot wire (red) to the driver output hot wire (red) using wire nut (A).

13. Connect supply ground wire (usually green or bare copper) around the green grounding screw (see diagram 1). Tighten.
    NOTE: It is imperative that the fixture is grounded.

14. Connect driver input neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).

15. Connect driver input hot wire (black) to the supply hot wire (usually black) using wire nut (A).
    CAUTION: Do not reverse the hot and neutral connections.

16. Insert driver into mounting plate bracket.

17.  Install canopy (D) to the collar loop and secure with collar ring (E).

Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>