NEOSMAY KC12 32GB RAM 1TB NVME SSD User Manual
- June 14, 2024
- NEOSMAY
Table of Contents
KC12 32GB RAM 1TB NVME SSD
User Manual
Overview
| 1. ON/OFF button | 7. USB 2.0 x 2 |
|---|---|
| 2. Type-C (thunderbolt) | 8. DP |
| 3. USB 3.0 x 4 | 9. HDMI |
| 4. MIC & Audio port | 10. LAN x 2 |
| 5. COM port | 11. Power supply DC IN |
| 6. HDMI | 12. Kensington Lock |
TURNING ON
Press and hold the ON/OFF Button for a couple of seconds to turn on your
computer
Power Supply
Connect the provided charger (19V4.74A/3.42A DC) to the power supply port, do
not use other than the provided charger.
ON/OFF button
You can see computer status by looking at the ON/OFF button.
Blue light: computer is turn on.
No light: computer is turn off or sleeping.
Installing SSD STORAGE or replace the SSD
You need to install an SSD drive and windows before you use the computer, You
can replace the SSD driver with more big capacity, if find the storage is not
enough. Important: The m.2 SSD could be SATA type, NVME is also supported, the
supported length of m.2 SATA SSD is 2280.
If you replace the SSD driver, driver is needed for using windows OS, it can
be downloaded from website www.newsmaytech.com
or contacts
a. Unscrew the screw on the hatch on the bottom
b. Insert or replace the m.2 2280 SSD in the orientation as on the picture
above
c. Screw the security screw to hold the SSD in place
d. Screw back the protection hatch
SAFETY INFORMATION
Operating temperature: 10℃ to 35℃, storage temperature: -25℃ to 4525℃, Relative humidity: 0% to 90%(noncondensing).
Built-in battery : Do not attempt to replace or remove the battery
yourself. You may damage the battery, which could cause overheating and
injury, The battery should be replaced by an authorized service provider, and
must be recycled or disposed of separately from household waste.
Liquid exposure: Keep your computer away from sources of liquid, such as
drinks, oils, lotions, sinks, bathtubs, shower stalls, and so on. Protect your
computer from dampness, humidity, or wet weather, such as rain, snow and fog.
Charging : charge only with the included power adapter, other power
adapters might not meet safety standards, and using such power adapters could
pose a risk of death or injury, using damaged power adapters or cables, or
charging when moisture is present, can cause fire, electric shock, injury, or
damage to your computer or other property. Do not use a power adapter in wet
locations, such as near a sink, bathtub, or shower stall, or connect or
disconnect the power adapter with wet hands.
BIOS : When boot the PC, then continuous Press F2 to into BIOS,
VESA MOUNT：
-
Fix bracket on MINI PC with screws.
-
Fix the bracket on the back of display with screws.
-
Fix bracket on MINI PC with screws
-
Fix the bracket on the back of display with screws.
Manufacture : Newsmay Technology Co.,Ltd
Web: www.newsmaytech.com
Phone: +86-0755-89456786
Email: info@newsmaytech.com
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum 20cm distance between the radiator and your body: Use only the supplied antenna.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>