ASTRONAUT MXS003 Night Light with Music Player User Manual
- June 14, 2024
- ASTRONAUT
Table of Contents
ASTRONAUT MXS003 Night Light with Music Player
INSTRUCTION
Attention
- The light source of stars and nebulae is strong, so eyes should not look directly at the light source.
- The brightness of the stars (ie laser brightness) is affected by the ambient temperature and time of use. When the ambient temperature is hot or the power-on time is longer, the brightness of the laser will decrease due to the heat of the light source. At this time, just turn off the power and let the laser emit The heat dissipation of the device (heat dissipation time usually takes more than 15 minutes), and then turn it on to restore the brightness.
- The head and body of the astronaut are connected by magnets, and the direction of the head can be adjusted. Do not stretch the astronaut’s head and body forcefully, otherwise, the wires may break due to stretching.
Host Key Operation Instructions
- Press and hold for three seconds to start the machine, Press and hold for three seconds to shut down, Tap lullaby, Tap Bluetooth profile
- Tap to close the nebula, Tap to close the projection of stars, Tap to turn off all lights, Tap to turn on all lights
- Tap Previous, Long press the volume to decrease
- Tap a song, Long press the volume to increase
Remote Control Instructions
- Material: ABS/PC/PVC
- Product Color: White
- Laser Wavelength: 532nm
- LED Power: < 5W
- Control Mode: Remote control
- Remote Control Range: < 5meters(Best distance)
- Power Supply: 100 – 240V~50/60Hz 0.4A
- Work Input: 5V-1A
- Product Size: 120113228mm
- Applicable Environment: Indoor Home (Better in a dark environment)
- Working Temperature: -10°~45°Celsius
FCC
FCC WARNING
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with a minimum 20cm distance between the radiator and your body: Use only the supplied antenna.