MERCUSYS MP500 KIT AV1000 Gigabit Power Line Starter Kit Instruction Manual
- June 14, 2024
- MERCUSYS
Table of Contents
MERCUSYS MP500 KIT AV1000 Gigabit Power Line Starter Kit Instruction Manual
Plug and Play
- Connect one adapter to a LAN port of your router using an Ethernet cable.
- Plug the other adapter into the wall outlets on the same electrical circuit.
- Wait until the Power LED on any adapter turns solid on.
- Connect your computer to the adapter using an Ethernet cable.
- Enjoy!
More: To add additional Powerline adapters and extenders with the default settings, simply plug them into the wall outlets on the same electrical circuit.
Attention
- Plug the powerline devices directly into the wall outlets but not the power strips.
- For passthrough powerline devices, plug the power strips into the integrated electrical sockets of the powerline devices.
Secure the Powerline Network with the Pair Button
Tips: We recommend that you plug in the powerline devices near each other when
pairing.
Set up a secure network:
- Press the Pair button for 1 second on one adapter.
- Within 2 minutes, press the Pair button for 1 second on another adapter.
- Done.
If you have more than 2 powerline devices, repeat the steps below on each additional devices to be configured:
- Press the Pair button for 1 second on any powerline device in the secure network.
- Within 2 minutes, press the Pair button for 1 second on the additional powerline device.
- Done.
FAQ (Frequently Asked Questions)
Q1. How do I reset my powerline adapter?
A1. With the powerline adapter plugged into to the electrical outlet, press and hold the Pair button until the Power LED goes off momentarily and comes back on.
Q2. How to troubleshoot if there is no internet connection in my powerline network?
A1. Make sure all powerline devices are on the same electrical circuit. A2. Make sure all Power LEDs are solid on. If not, pair your adapters and extenders again. A3. Make sure all hardware connections are correctly and securely connected. A4. Check if you have an internet connection by connecting the computer directly to the modem or router. A5. Make sure your computer’s IP address is in the same segment as your router’s.
Q3. What can I do if a successfully-paired powerline device does not reconnect after it has been moved to a new location?
A1. Try another socket and make sure it is on the same electrical circuit. A2. Try to pair it again, and make sure the Power LED is solid on. A3. Check for possible interference, such as a washer, air conditioner or other household appliances that may be too close to one of the powerline devices. Plug the appliance into the integrated electrical socket (if the powerline device has one) to remove some electrical noise.
To learn more about the powerline adapter, please visit our website http://www.mercusys.com .
http://www.mercusys.com/
Specifications are subject to change without notice. is a registered trademark
of MERCUSYS TECHNOLOGIES CO., LTD. Other brands and product names are
trademarks or registered trademarks of their respective holders.
No part of the specifications may be reproduced in any form or by any means or
used to make any derivative such as translation, transformation, or adaptation
without permission from MERCUSYS TECHNOLOGIES CO., LIMITED. Copyright © 2020
MERCUSYS TECHNOLOGIES CO., LIMITED. All rights reserved.
? For technical support, the user guide and more information, please visit http://www.mercusys.com/support
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>