AMZNOONE 6000LM Outdoor Indoor Under Hood Magnetic Work Light User Manual

AMZNOONE 6000LM Outdoor Indoor Under Hood Magnetic Work Light User Manual

Warnings and symbols used

The following warnings are used in this user manual and on the packaging:

| Direct current/voltage|

| Alternating current/voltage

| Protection class III|

| Polarity of output terminal

| Protection class II|

| Product designed to withstand severe mechanical handling.

| (SMP) Switch mode power supply unit| | USB connection symbol

| Short-circuit-proof safety isolating transformer|

| Read user manual before use.

| CE mark indicates conformity with relevant EU directives applicable for this product.|

| Minimum distance to illuminated material

| To indicate that the power supply unit shall not be used, if pins of the plug part are damaged.|

| Dust-tight/water jet protected (IP65)

| Press ON/OFF switch [2.|

LED Work Light

Short manual
This document is a shorter printed version of the complete instruction manual

WARNING! Observe the complete instruction manual and safety notes to prevent personal injury and property damage . The short guide forms an integral part of  this product . Prior to using the product, familiarize yourself with all operation and safety notes

Intended use

The product is intended for use at indoor or outdoor areas without electrical connection, e .g . workshop, garages, or garden sheds, etc. . The product features 2 brightness settings plus white flashing light and red flashing light .

This product is intended for use in private, domestic environment only and not for commercial purposes .

ATTENTION: Red flash modes switch(it can be used as a warning sign in emergency situations). The product can further also be used as a power bank for small

 electronic devices with USB charging

Scope of delivery

After unpacking the product, check if the delivery is complete and if all parts are in good condition . Remove all packing materials before use .

• Cordless work light
• USB cable
• Instructions for use
• Exquisite storage box

Product weight: 700 g
Overall dimensions: 165 x 150 x 44 mm

For indoor and outdoor use

Description of part

1. LED light
2. ON/OFF switch
3. Screw of hinge joint
4. Adjustable foot/Hand grip
5. Magnet
6. Charging indicator
7. Battery status button
8. Protective cap
9. USB input socket (type C)
10. USB output socket
11. USB cable
    

Technical data

Flashlight and work light
LEDs: 1 COB LED (non-replaceable); approx . 20 W
Rechargeable battery: Lithium-Ion rechargeable battery, 3 .7 V, 6000 mAh 22 .2 Wh (not interchangeable)
Charging time for drained battery: approx . 3 .5 hours

Light duration (with fully loaded rechargeable battery):
White light at max. mode: approx. 3. 5 hours
White light at Eco mode: approx. 6.5 hours
Red light blinking: approx. 60 hours

Protection type

Product: IP65

(While charging or when using as a power bank: Use only in indoor areas. This product is only Dust-tight/ water jet proof (IP65) with the protective cap 8 attached to it). USB cable 11 for indoor use only

USB input voltage/current: 5V, 2A
USB socket output voltage/current: 5V, 2.1 A

Safety instructions

BEFORE USING THE PRODUCT, FAMILIARISE YOURSELF WITH ALL OF THE SAFETY INFORMATION AND INSTRUCTIONS FOR USE! WHEN PASSING THIS PRODUCT ON TO OTHERS, ALSO INCLUDE ALL THE DOCUMENTS!

WARNING! DANGER TO LIFE AND RISK OF ACCIDENTS FOR INFANTS AND CHILDREN!

Never leave children unsupervised with the packaging material. Always keep children away from the packaging material .

• This product may be used by children aged  8 years and up, as well as by persons with reduced physical, sensory or mental capacities, or those lacking experience and/ or knowledge provided they are supervised  or instructed in the safe use of the product and they understand the associated risks. Do not allow children to play with the product. Cleaning and user maintenance must not be performed by children without supervision.
• This product is not a toy and should be kept out of the reach of children. Children are not aware of the dangers associated with handling electrical products.
• Do not use the product if you detect any type of damage.
• Never immerse the product in water or other liquids!
• Only connect the product to a properly installed mains socket or a suitable 12 V car charging socket. The voltages in each case must comply with information given in the section “Technical data”.
• Ensure that the electrical socket is easily accessible so that you can pull the power
• Do not carry out any modifications or repairs to the product yourself . The LEDs cannot and must not be replaced .
• The LEDs are not replaceable .
• If the LEDs fail at the end of their lives, the entire product must be replaced.

CAUTION! DANGER OF BURN INJURIES!

• To prevent burns, verify the
• product is switched off and has cooled down for at least 15 minutes before touching it . The product can become very hot .
• The accessible surface, especially heat shrink, is very hot when the lamp is operating .
  FIRE HAZARD! Fit the product so that it is at least 0 .1 meter away from the material to be illuminated .
  Excessive heat can result in a fire .

WARNING! Do not turn on the light when the product is facing down to combustible surface . The exposed surface may be overheated or ignited .

• Do not place burning candles or open fire on or near the product .
• Do not use the product near heat sources such as radiators or devices emitting heat .
• Dispose of the product if product or USB cable are damaged .
• Ensure the USB cable cannot become damaged by sharp edges or hot objects .
• Unwind the USB cable completely before use .
• Observe the usage restrictions and prohibitions of use for battery-operated products in situations which may be  hazardous such as at petrol stations, airports, hospitals, etc .
  WARNING! Do not cover the product while charging . There is a risk of warming and overheating .

Safety instructions for batteries/ rechargeable batteries

DANGER TO LIFE! Keep batteries/
rechargeable batteries out of reach of children. If accidentally swallowed seek immediate medical attention.

DANGER OF EXPLOSION!
Never recharge non-rechargeable batteries. Do not short-circuit batteries / rechargeable batteries and / or open them. Overheating, fire or bursting can be the result

• Never throw batteries / rechargeable batteries into fire or water.
• Do not exert mechanical loads to batteries / rechargeable batteries.

Risk of leakage of batteries/ rechargeable batteries

• Avoid extreme environmental conditions and temperatures, which could affect batteries / rechargeable batteries, e.g. radiators / direct sunlight.
• If batteries / rechargeable batteries have leaked, avoid contact with skin, eyes and mucous membranes with the chemicals! Flush immediately the affected areas with fresh water and seek medical attention!

WEAR PROTECTIVE GLOVES!

Leaked or damaged batteries / rechargeable batteries can cause burns on contact with the skin. Wear suitable protective gloves at all times if such an event occurs.

• This product has a built-in rechargeable battery which cannot be replaced by the user. When disposing of the product, it should be noted that this product contains a rechargeable battery.

Charging the product

NOTES:

• Remove all packaging materials from the product.
• You can charge the product by means of the supplied power adaptor to a normal household socket, or by means of the supplied car adaptor to a 12 V car cigarette lighter socket.

CAUTION! Do not connect the product to your car’s 12 V connection if the car battery is already old and worn. Doing so could mean that the car engine will no longer start.

NOTES:

• In order to use the product without a USB cable you need to recharge the rechargeable battery before use. The charging process takes about 3.5 hours. The rechargeable battery is firmly integrated into the base of the product.
• Fully charge the rechargeable battery prior to first use. Charge the battery if it becomes empty (only 1 LED of the charging indicator 6 is flashing).
• Open the protective cap 8.
• Connect the USB cable 11 with the USB connector of the power adaptor or the car charger adaptor.
• Connect the USB plug (type C) of the USB cable to the USB input socket (type C) 9 on the product.

NOTES:

• The battery charging status is shown by the charging indicator 6:

Charging indicator 6 status: Battery charging status

1 LED flashes: 0-25%
1 LED lights up, 1 LED flashes: 25-50%
2 LEDs light up, 1 LED flashes: 50-75%
3 LEDs light up, 1 LED flashes: 75-100%
4 LEDs light up: 100%

• The charging time is approximately 3.5 hours when the battery was drained.

NOTE: The product has an overcharging protection system. Nevertheless, you should disconnect the product from the mains once the charging process is complete.

• Disconnect the USB cable from the product to prevent the batteries discharging themselves.
• Close the protective cap 8 before you start to use the product again. Otherwise water could enter to the product when it is used outdoors.

Checking the battery capacity

When product is not charged: Press the battery status button to check the battery capacity. The green charging indicator 6 shows the capacity* of the battery inside the product.

1 LED lights up: 25%
2 LEDs light up: 50%
3 LEDs light up: 75%
4 LEDs light up: 1 00%

• This is the approximate percentage of battery capacity but not actual measurement

Operation

RISK OF ACCIDENT! Preferably do not use the product whilst driving the vehicle. When using the product in a vehicle, be sure this does not endanger the driver or the passengers. Always store and secure the product so that even full braking does not pose a risk of injury from the product or product damage.

• Turn the adjustable foot / hand grip 4 and fix the product at desired position. For that tighten the screw of the hinge joint 3 by hand. The adjustable foot / hand grip 4 can also be turned up by approximately 180° and be used as a hand grip.
• The product can also be fixed by attaching it to a flat ferromagnetic surface with the magnet 5 of the adjustable foot/handle 4.
  

CAUTION! Please note the position of your hands whilst turning the adjustable foot / hand grip 4 to prevent pinching your fingers.

• The product may be used as a light and a power bank.

NOTE: The energy stored in the rechargeable batteries power both the LED light and the power bank. Using the product as a power bank therefore reduces the operating time and brightness in lighting mode.

Using as a LED light

• Fully charge the product as described in the section “Charging the product”.
• The product can be operated in 4 different modes. Select these by repeatedly pressing the ON/OFF switch 2.

• ATTENTION! The flashing red light can have adverse effects on the health of predisposed individuals!
• The flashing light is not suitable as a traffic warning light.

Press 4x:| Switch off the light.
Long Press:| Switch off the light.

Using as a power bank

When used with the USB cable 11, the product may be used to charge small electronics devices with USB socket (type C) for charging (e.g. mobiles or digital cameras).

• Please note, the charging current the device requires may not exceed 2 A. Carefully read the instructions for use of the device you wish to charge.

ATTENTION! Charging a device which requires a higher charging current may cause a defect in both devices.

• Also note, the battery of the device you wish to charge must have a significantly smaller capacity than the total capacities of the rechargeable batteries inside the product (6000 mAh). Otherwise charging may not complete.
• Open the protective cap 8
• Insert the USB plug of the USB cable into the USB output socket 10.
• Insert the USB plug (type C) of the USB cable 11 into the small electronic devices you wish to charge. The green charging indicator 6 lights up, indicating the battery capacity.
• Remove the USB cable 11 as soon as charging is complete.
• Close the protective cap 8

Maintenance and cleaning

The product requires no maintenance. The LEDs cannot be replaced.

• Switch off the product and disconnect the power adaptor from socket or unplug the car charger adaptor from the 12 V socket before cleaning.
• Close the protective cap 8 on the USB input socket 9 and USB output socket 10.
• Never immerse the product in water or other liquids.
• Never use caustic cleaners.
• Regularly clean the product with a dry, lint-free cloth. Use a slightly moist cloth to remove any stubborn dirt.

Disposal

The packaging is made entirely of recyclable materials, which you may dispose of at local recycling facilities.

Observe the marking of the packaging materials for waste separation, which are marked with abbreviations (a) and numbers (b) with following meaning: 1-7: plastics / 20-22: paper and fibreboard / 80-98: composite materials.

The product and packaging materials are recyclable, dispose of it separately for better waste treatment.
The Triman logo is valid in France only.

Contact your local refuse disposal authority for more details of how to dispose of your worn-out product.

To help protect the environment, please dispose of the product properly when it has reached the end of its useful life and not in the household waste. Information on collection points and their opening hours can be obtained from your local authority.

Faulty or used batteries / rechargeable batteries must be recycled in accordance with Directive 2006/66/EC and its amendments. Please return the batteries / rechargeable batteries and/or the product to the available collection points.

Environmental damage through incorrect disposal of the batteries / rechargeable batteries!

Batteries/rechargeable batteries may not be disposed of with the usual domestic waste. They may contain toxic heavy metals and are subject to hazardous waste treatment rules and regulations. The chemical symbols for heavy metals are as follows: Cd – cadmium, Hg mercury, Pb = lead. That is why you should dispose of used batteries / rechargeable batteries at a local collection point.

Service

Email: [email protected]

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>