hansgrohe Croma Komplet prysznicowy 160 1jet z termostatem Instruction Manual
- June 14, 2024
- hansgrohe
Table of Contents
- hansgrohe Croma Komplet prysznicowy 160 1jet z termostatem
- Safety Notes
- Technical Data
- Symbol Description
- Installation Instructions
- Dimensions
- Flow diagram
- Adjustment
- Safety Function
- Maintenance And Cleaning
- Operation
- Spare parts
- Test certificate
- Warranty
- Contact
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
hansgrohe Croma Komplet prysznicowy 160 1jet z termostatem
Safety Notes
- Gloves should be worn during installation to prevent crushing and cutting injuries.
- The product may only be used for bathing, hygienic and body cleaning purposes.
- The arm of the shower head is intended only to hold the shower head. Do not load it down with other objects!
- Children as well as adults with physical, mental and/or sensoric impairments must not use this product without proper supervision. Persons under the influence of alcohol or drugs are prohibited from using this product.
- Do not allow the streams of the shower touch sensitive body parts (such as your eyes). An adequate distance must be kept between the shower and you.
- The product may not be used as a holding handle. A separate handle must be installed.
- The hot and cold supplies must be of equal pressures.
Installation Instructions
- Prior to installation, inspect the product for transport damages. After it has been installed, no transport or surface damage will be honoured.
- The pipes and the fixture must be installed, flushed and tested as per the applicable standards.
- The plumbing codes applicable in the respective countries must be observed.
- The installation dimensions stated in these installation instructions are ideal for people of approximately 1800 mm in body height. The dimensions can be altered if required. In this case, pay attention to the fact that a change of installation height will also change the minimum height, and that the altered mounting dimensions must be taken into consideration.
- During installation of the product by qualified trained personnel, make sure that the entire fastening surface is even and smooth (no protruding seams or tile offset), that the finish of the wall is suitable to apply the product and has no weak points.
- The filter insert must be used to protect the shower against incoming dirt by pipework. Incoming dirt leads to defects or/and can damage parts of the shower; such caused faults voids all liability and guarantee claims.
- The product is not designed to be used with steam baths!
- If required, the bottom part of the pipe between the fixture and the shower head can be shortened with a fine-toothed saw.
- If the continuous water heater causes any problems, or you have different water pressures you must install a water limiter to the cold supply, (ordered separately, article number 97510000).
- Safety against backflow.
- The product is exclusively designed for drinking water!
Technical Data
- Operating pressure: max. 1 MPa
- Recommended operating pressure: 0,1 – 0,5 MPa
- Test pressure: 1,6 MPa
- (1 MPa = 10 bar = 147 PSI)
- Hot water temperature: max. 60°C
- Centre distance: 150±12 mm
- Connections G 1/2: cold right – hot left
- Thermal disinfection: 70°C / 4 min
Symbol Description
Symbol Description
- Do not use silicone containing acetic acid!
Safety Function
- The desired maximum temperature for example max. 42º C can be pre-set thanks to the safety function.
Adjustment
- After the installation, the output temperature of the thermostat must be checked.
- A correction is necessary if the temperature measured at the output differs from the temperature set on the thermostat.
Maintenance
- The check valves must be checked regularly according to EN 806-5 in accordance with national or regional regulations (at least once a year).
- To guarantee the smooth running of the thermostat, it is necessary from time to time to turn the thermostat from total hot to total cold.
Dimensions
Flow diagram
- Overhead shower
- Hand shower
Spare parts
- Special accessories (order as an extra) tile-matching-disk Chrome Plated #95239000
- Cleaning
- Operation
- To empty the overhead shower after use, hold it in a slightly inclined position.
- Test certificate
Installation Instructions
Dimensions
Flow diagram
Adjustment
Safety Function
Maintenance And Cleaning
Maintenance
Cleaning
Cleaning recommendation / Warranty / Contact
Just clean
- simply rub over the spray nozzles to remove lime scale.
Operation
open
close
cold / hot
Croma 100 Vario
- 28535000
Spare parts
Croma Showerpipe
- 27135000 / 27891000
Test certificate
Warranty
- 5 Years Warranty
- www.hansgrohe.com/cleaning-recommendation
Contact
Hansgrohe
- Auestraße 5 – 9 · D-77761 Schiltach
- Telefon: +49 (0) 78 36/51-1282
- Telefax: +49 (0) 7836/511440
- E-Mail: info@hansgrohe.com
- Internet: www.hansgrohe.com
References
- Taps for bathrooms, showers and kitchens | hansgrohe INT
- Web Server's Default Page
- Taps for bathrooms, showers and kitchens
- Taps for bathrooms, showers and kitchens
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>