greenworks LMF318 Cordless Lawn Mower Instruction Manual

GreenWorks LMF318 Cordless Lawn Mower

DESCRIPTION

PURPOSE

• This machine is used for domestic lawn mowing. The cutting blade must be approximately parallel to the ground. All four wheels must touch the ground while you mow.

OVERVIEW

1. Quick-release lever
2. Lower handle
3. Upper handle
4. Knob
5. Cam lock
6. Grass catcher
7. Rear discharge flap
8. Mulch plug
9. Height adjustment button
10. Battery compartment flap
11. Battery pack
12. Safety key
13. Start button
14. Bail switch
15. Front-wheel
16. Rear wheel
17. Slot
18. Mounting nut
19. Spacer
20. Blade

SAFETY

WARNING

• Make sure that you follow all safety instructions.
• Refer to the Safety Manual.

INSTALLATION

WARNING

• Do not use accessories that are not recommended by the manufacturer.

WARNING

• Do not put in the safety key or the battery pack until you finalized the assembly of all the parts.

UNPACK THE MACHINE

WARNING

• Make sure that you correctly assemble the machine before use.

WARNING

• If parts of the machine are damaged, do not use the machine.
• If you do not have all the parts, do not operate the machine.
• If the parts are damaged or missing, contact the service center.

1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with local regulations.

UNFOLD AND ADJUST THE LOWER HANDLE

1. Pull up and back the upper handle to lift the handle into the operation position. Make sure that the handles click into position correctly.
2. Tighten the lower handle with the quick-release levers on the two sides.

NOTE

• Make sure that the two handles are in the same position.

WARNING

• Do not make damage to the cables when you fold or unfold the handle.

INSTALL THE UPPER HANDLE

1. Align the holes in the upper handle and the lower handle.
2. Put the cam locks through the holes.
3. Tighten the knobs onto the cam locks.
4. Do the same operation on the other side.

INSTALL THE GRASS CATCHER

1. Remove the mulch plug.
2. Open the rear discharge flap and hold it.
3. Hold the grass catcher by its handle and put the hooks over the slots.
4. Close the rear discharge flap.

INSTALL THE MULCH PLUG

1. Remove the grass catcher.
2. Open the rear discharge flap and hold it.
3. Hold the mulch plug by its handle and fit it in the discharge chute.
4. Close the rear discharge flap.

SET THE BLADE/CUTTING HEIGHT
The machine can be set to different blade/cutting heights.

1. Push the height adjustment button, and move the height adjustment gear to a higher position to increase the blade/cutting height.
2. Push the height adjustment button, and move the height adjustment gear to a lower position to decrease the blade/cutting height.

INSTALL THE BATTERY PACK

WARNING

• If the battery pack or charger is damaged, replace the battery pack or the charger.
• Stop the machine and wait until the engine stops before you install or remove the battery pack.
• Read, know, and follow the instructions in the battery and charger manual.

1. Open the battery door.
2. Align the lift ribs on the battery pack with the grooves in the battery compartment.
3. Push the battery pack into the battery compartment until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door

NOTE

The engine starts only when you put in the safety key.

REMOVE THE BATTERY PACK

1. Open the battery door.
2. Remove the safety key.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.

OPERATION

WARNING
Wear eye protection during operation.
START THE MACHINE

1. Put in the safety key and battery.
2. Push and hold the start button.
3. While you hold the start button, pull the bail switch in the direction of the handle bar.
4. Release the start button to start the machine.

STOP THE MACHINE

1. Release the bail switch to stop the machine.

WARNING
Wait until the blades fully stop before you start the machine again. Do not quickly turn the machine off and on.
WARNING
Always remove the safety key and battery pack after you complete the work.

EMPTY THE GRASS CATCHER

1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge door and hold it.
5. Hold the grass catcher by its handle and unhook it from the slots.
6. Close the rear discharge door.
7. Empty the grass catcher.

OPERATE ON SLOPES

WARNING

• Do not mow on slopes with an incline of more than 15°. If you are not comfortable, do not mow on a slope.
• Do not go up and down on a slope, mow across the face of the slope. Be careful when you change the direction on a slope.
• Monitor holes, ruts, rocks, and other hidden objects that can cause you to fall. Remove all obstacles such as rocks and tree limbs.
• Make sure that your footing is stable. If you are out of balance, release the handle switch immediately.
• Do not mow near drop-offs, ditches, or embankments.

OPERATION TIPS

• Do not try to override the operation of the start button or bail switch.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick grass.
• Clean the bottom of the mower deck after each use. Remove grass clippings, leaves, dirt, and other debris.

MAINTENANCE

WARNING

• Remove the safety key and battery pack from the machine before maintenance.
• Keep the engine and battery pack free from grass, leaves, or too much grease.

CAUTION

• Use only approved replacement parts.
• Do not let brake fluids, gasoline, or petroleum-based materials touch the plastic parts. Chemicals can cause damage to the plastic, and make the plastic unserviceable.
• Do not use strong solvents or detergents on the plastic housing or components.

GENERAL MAINTENANCE

• Before each use, examine the machine for damaged, missing, or loose parts such as screws, nuts, bolts, and caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use water.

LUBRICATION

• Apply a sufficient quantity of high-grade lubricant to all bearings. No more bearing lubrication is necessary in usual operation conditions.

WARNING

• Do not lubricate the wheel components. Lubrication can cause damage to the wheel components during operation.

REPLACE THE BLADE

• Use only approved replacement blades.
• Wear heavy gloves or wind cloth around the blade when you touch the blade.

1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the blade.
6. Remove the mounting nut and spacer with a wrench or socket.
7. Remove the blade.
8. Install the new blade. Make sure that the raised points engage the hole(s) in the blade.
9. Put in the mounting nut and spacer and tighten them.

STORE THE MACHINE

• Remove the safety key.
• Remove the battery pack(s).
• Clean the machine before storage.
• Make sure the motor is not hot when you store the machine.
• Make sure that the machine does not have loose or damaged parts.
• If it is necessary, follow these instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person at an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.

TROUBLESHOOTING

• If you cannot find the solution to these problems, go to the service center.

TECHNICAL DATA

WARRANTY

• (The full warranty terms and conditions can be found on the Greenworks webpage)
• The Greenworks warranty is for 3 years on the product and 2 years on batteries (consumer/private usage) from the date of purchase. This warranty covers manufacturing faults. A faulty product under warranty might be either repaired or replaced.
• A unit that has been misused or used in other ways than described in the owner’s manual might be rejected for warranty. Normal wear and wear parts are not considered a warranty. The original manufacturer warranty is not affected by any additional warranty offered by a dealer or retailer.
• A faulty product must be returned to the point of purchase in order to claim for warranty, together with the proof of purchase (receipt).

EC DECLARATION OF CONFORMITY

• Name and address of the manufacturer:
• Name: GLOBGRO AB
• Globe Group Europe
• Address: Riggaregatan 53, 211 13 Malmö, Sweden
• Name and address of the person authorized to compile the technical file:
• Name: Micael Johansson
• Address: Riggaregatan 53, 211 13 Malmö, Sweden

Herewith we declare that the product

• Category: Lawn Mower
• Model: 2504707 (LMF318)
• Serial number: See product rating label
• Year of Construction: See product rating label is in conformity with the relevant provisions of the Machinery Directive 2006/42/EC.
• is in conformity with the provisions of the following other EC-Directives:
• 2014/30/EU
• 2000/14/EC & 2005/88/EC
• 2011/65/EU & (EU)2015/863
• Furthermore, we declare that the following parts, and clauses of harmonised standards have been used:
• EN 60335-1, EN 60335-2-77, EN 62233, EN ISO 3744, EN 55014-1, EN 55014-2, ISO 11094, IEC 62321-3-1, IEC 62321-4, IEC 62321-5, IEC 62321-6, IEC 62321-7-1, IEC 62321-7-2. IEC 62321-8
• Conformity assessment method to Annex VI Directive 2000/14/EC.
• Measured sound power level LWA: 90,3 dB(A)
• Guaranteed sound power level LWA.d : 92 dB(A)
• Place, date: Malmö, 03.03.2021
• Signature: Ted Qu, Quality Director

DECLARATION OF CONFORMITY

• Name and address of the manufacturer:
• Name: GLOBGRO AB
• Globe Group Europe
• Address: Riggaregatan 53, 211 13 Malmö Sweden
• Name and address of the Authorized representative:
• Name: Garden Equipment Ltd
• Address: 3a Groveley Road, Christchurch, Dorset, BH23 3HB, UK
• Name and address of the person authorized to compile the technical file: Name: Simon Del-Nevo
• Address: 3a Groveley Road, Christchurch, Dorset, BH23 3HB, UK
• Here we declare that the product
• Category: Lawn Mower
• Model: 2504707 (LMF318)
• Serial number: See product rating label
• Year of Construction: See product rating label
• is in conformity with the relevant provisions of the Supply of Machinery (Safety) Regulations 2008.
• is in conformity with the provisions of the following other UK legislation:
• Electromagnetic Compatibility Regulations 2016
• Noise Emission in the Environment by Equipment for use Outdoors Regulations 2001
• The Restriction of the Use of Certain Hazardous
• substances in Electrical and Electronic Equipment Regulations 2012
• Furthermore, we declare that the following standards have been used:
• BS EN 60335-1, BS EN 60335-2-77, BS EN 62233, BS EN 55014-1, BS EN 55014-2,
• BS EN ISO 3744, ISO 11094, BS EN 62321-3-1, BS EN 62321-4, BS EN 62321-5,
• BS EN 62321-6, BS EN 62321-7-1, BS EN 62321-7-2, BS EN 62321-8
• Conformity assessment method to Annex E Noise Emission in the Environment by Equipment for use Outdoors Regulations 2001.
• Measured sound power level 90,3 dB(A)
• Guaranteed sound power level 92 dB(A)
• Place, date: Christchurch, Dorset, UK 07.06.2021 Signature: Ted Qu, Quality Director
• www.greenworkstools.eu

Documents / Resources

| greenworks LMF318 Cordless Lawn Mower [pdf] Instruction Manual
LMF318 Cordless Lawn Mower, LMF318, Cordless Lawn Mower, Lawn Mower, Mower
---|---

References

• Powerful Cordless Gardening Tools | Greenworks Tools

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>