OXIPRO TH1 4-in-1 Digital Baby and Adult Thermometer Instruction Manual

: June 14, 2024
: OXIPRO

Table of Contents

OXIPRO TH1 4-in-1 Digital Baby and Adult Thermometer
Product Information
Install the batteries
Temp Setup
Setting the Mode of Measurement
Selecting the Mode of Measurement
Forehead & Surface Measurement
In-Ear Measurement
Results & Recall
Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

OXIPRO TH1 4-in-1 Digital Baby and Adult Thermometer

OXIPRO TH1 4-in-1 Digital Baby and Adult Thermometer-
product

Product Information

Infrared thermometer for non-contact temperature measurement
Designed for use on the forehead
Features a slide switch for selecting the unit of measure
Includes a mode/memory recall button for setting the mode of measurement
Powered by 2 x AAA batteries (supplied)

Install the batteries

Turn the thermometer over so the back is facing you. Slide the battery cover open. Insert the supplied 2 x AAA batteries.

Temp Setup

Set the unit of measure to Celsius (°C ) or Fahrenheit (°F).

Open the battery cover.
Locate the slide switch shown here.
Slide it to your desired unit of measure.

Getting to Know the Buttons and Display

Setting the Mode of Measurement

You can choose between four methods of measurement

Forehead (>12 years old)
Forehead (<12 years old)
In-ear
Surface

The current mode is shown on the top line of the display.

Selecting the Mode of Measurement

Forehead and Surface Modes
Click the “Mode” button to change between forehead and surface modes.

Switching to In-Ear Mode
Remove the magnetic cap at the back of the thermometer to change to In-Ear mode. Replace the cap to change back to Forehead/Surface modes.

Forehead & Surface Measurement

Click the mode button until correct forehead icon is displayed for age Aim at the centre of the forehead, 0-3cm from the skin and press the measurement button.

Click the mode button until surface icon is displayed Aim the sensor 0-3cm from] surface and press the measurement button.

In-Ear Measurement

Power on
Remove the magnetic cap. Check the sensor lens & probe are clean.

Ensure the ear is clean and free from wax. Gently insert the probe into the ear canal, making sure it is straight. Do not force the probe into the ear. Be careful.

Press the measure button to take your reading. Clean the sensor lens after use.

Results & Recall

Results are color coded as shown

Power on & Standby
32ºC to 37.5ºC (89.6ºF to 99.5ºF)
37.6ºC to 38.0ºC (99.7°F to 100.4°F
38.1ºC to 42.9ºC (100.6°F to 109.2°F)

Memory Recall
Press and hold the mode/memory key for 5 seconds. Press the mode key again to show the next result.

IMPORTANT

ALWAYS KEEP THE MEASUREMENT PROBE AND LENS CLEAN. USE AN ALCOHOL SWAB OR COTTON SWAB WITH 70% ALCOHOL TO CLEAN THE LENS PROBE AND CASING. AFTER THE ALCOHOL HAS COMPLETELY DRIED OUT YOU CAN TAKE A NEW MEASUREMENT.
AWAYS MAKE SURE THE USER AND THE THERMOMETER HAVE BEEN IN THE SAME ROOM FOR AT LEAST 30 MINUTES PRIOR TO MEASUREMENT.
DO NOT PERFORM BACK TO BACK ˜ SEQUENTIAL TESTS°, THE SENSOR WILL BECOME HOT AND READINGS WILL BECOME INACCURATE.
WAIT AT LEAST 10 SECONDS BETWEEN TESTS, REMOVING THE PROBE FROM THE TEST SUBJECT EACH TIME.