OXIPRO BP1 Blood Pressure Monitor User Guide
- May 15, 2024
- OXIPRO
Table of Contents
OXIPRO BP1 Blood Pressure Monitor User Guide
FIRST TIME SETUP
a. Turn blood pressure monitor over, remove battery cover and install
batteries
b Connect arm cuff
TAKING A READING
a.Remove thick clothing from around the upper arm. If rolling up, make sure it doesn’t become tight around your arm.
b. For the most accurate results:
- relax, sitting down for 4-5 minutes before a reading.
- test at the same time each day.
- don’t perform several tests in a row
C. Insert arm in cuff and position as shown. Close velcro so the cuff is snug but not tight.
d. Press START on blood pressure monitor and don’t move or talk while it
performs reading.
UNDERSTANDING YOUR RESULTS
Your reading consists of two numbers: your Systolic Blood Pressure (SYS) and
Diastolic Blood Pressure (DIA). Readings are expressed with SYS over DIA. In
the example below, your reading would be 118/70 (118 over 70).
Find the point on the chart where your SYS and DIA readings intersect to see
your indicted blood pressure range. This chart is suitable for adults of all
ages
DIA mmHg (bottom number) Source: The NHS
MEMORY RECALL
Press memory button to scroll through previous results. NOTE: The first result shown is an average of the last three readings
| Issue | Cause | Solution |
|---|---|---|
| A reading outside your expected range | Cuff may be incorrectly fitted | Refit |
the cuff according to the instructions
Talking or moving during the measurement| Relax, stay still and don’t talk
during measurement
Clothing could be interfering with blood flow to the arm| Clear the arm of
clothing and try again
The cuff does not Inflate| The cuff is not connected to the machine or It is
not securely connected.| Check the cuff Is correctly attached to the machine,
refit the cuff to the machine and your arm according to the instructions and
try again
Cuff deflates too quickly| The cuff is too lose
Powers down duringmeasurement| The batteries may be low| Install new batteries
Does not power up afterpressing Start/Stop| Batteries may be exhausted|
Install new batteries
Batteries may be inserted the wrong way| Reinstall the batteries the right way
round
Error code is displayed| Please see the full user manual in the box| Please
see the full user manual in the box
If the above does not solve your issue, please feel free to contact us.
TECHNICAL SUPPORT
We’re here to help!
www.alcosense.co.uk/oxipro
info@alcosense.co.uk
UK: 01628 778885
IRL: 01 513 7065 Lines open Mon-Fri 0900-1700
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>