Franklin Brass P29523Z-FB-B Fulton Cabinet Knob Instruction Manual

Franklin Brass P29523Z-FB-B Fulton Cabinet Knob

Product Information

This product is a set of knobs and pulls for drawers, upper cabinets, and lower cabinets. It comes with a 3/16-inch drill bit, a pencil, a measuring ruler or tape, and optional masking tape.

Product Usage Instructions

1. Before you begin, gather all the necessary tools and materials mentioned above.
2. Decide on the placement of knobs and pulls for your drawers, upper cabinets, and lower cabinets.
3. Using the provided 3/16-inch drill bit, drill holes in the designated spots for the knobs and pulls.
4. Once the holes are drilled, insert the knobs and pull into the holes and secure them tightly.
5. If desired, use masking tape to mark the exact placement of the knobs and pulls before drilling.
6. After installation, refer to the user manual for proper use and care instructions to ensure the longevity of the product.

Note: The user manual also provides common placement suggestions for drawers, upper cabinets, and lower cabinets. It includes a specific model number, CP4474, for reference.

Cabinet Hardware Installation Instructions

Before You Begin

• Read the installation instructions completely before starting.
• Take care not to scratch your cabinets and countertops while working with tools.

Recommended Tools

Step 1

• Decide where you would like to install your knobs and/or pulls. Common locations are illustrated below.
• For pulls, measure between the holes on the back to determine the correct center-to-center hole spacing. 3” is the most common spacing but there are numerous options to choose from.

Step 2

• To prevent damage while drilling, place masking tape in the approximate hole locations on the cabinet or drawer fronts prior to measuring.
• Carefully measure and mark each hole location using a ruler or tape measure and pencil.
• For drawers, it may be helpful to measure down the same distance on either side and lightly scribe a horizontal line with a pencil. Be sure to check for level.
• Alternatively, a reusable cabinet hardware installation template can be purchased and used to ensure accurate placement. (Liberty AN0191C-G-Q1)

Step 3

• Carefully drill through the drawer and/or door fronts. Be sure to go slow and use minimal pressure to reduce splintering on the backside of the surface.

Step 4

• Install the new cabinet hardware using a screwdriver and the fasteners provided.
• Be careful not to over-tighten the screws.

©2010 Liberty Hardware Manufacturing Corporation, A MASCO COMPANY

Use and Care

Polish with a soft cloth. Do not use abrasive waxes or cleaners.

Hardware Placement

Drawers

Upper Cabinets

Lower Cabinets

Documents / Resources

| Franklin Brass P29523Z-FB-B Fulton Cabinet Knob [pdf] Instruction Manual
P29523Z-FB-B Fulton Cabinet Knob, P29523Z-FB-B, Fulton Cabinet Knob, Cabinet Knob, Knob
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>