TECH LIGHTING 700FMSEN13 Sen 17 Flush Mount Instruction Manual
- June 4, 2024
- TECH LIGHTING
Table of Contents
TECH LIGHTING 700FMSEN13 Sen 17 Flush Mount
GENERAL PRODUCT INFORMATION
These fixtures are intended to be installed utilizing NEC-compliant junction
boxes. This product is suitable for damp locations. This product can be dimmed
with most ELV, TRIAC, or 0-10V dimmers. This instruction shows a typical
installation.
CAUTION – RISK OF FIRE
This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product
and the hazards involved.
Use minimum 90°C supply conductors
SAVE THESE INSTRUCTIONS!
Install the Fixture
- Separate the mounting plate from the fixture by removing the knurled nuts.
- Install the mounting plate to the junction box with the provided #8-32 screws.
- Connect the fixture to a suitable ground in accordance with local electrical codes.
- Connect the white fixture wire to the neutral power line with a wire nut.
- Connect the black fixture wire to the hot power line with a wire nut.
- Properly place the wires and wire nut connections into the junction box and install the fixture base by aligning the holes to the mounting studs on the mounting plate. Secure its place with the knurled nuts.
- Install the shade onto the fixture base and secure its place with the set screws and provided an Allen wrench.
©2021 Tech Lighting, L.L.C. All rights reserved. The Tech Lighting logo is a registered trademark of Tech Lighting. Tech Lighting reserves the right to change specifications for product improvements without notification. 7400 Linder Ave., Skokie, IL 60077 T 847.410.4400 | F 847.410.4500 www.techlighting.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>