Instructions for Use

(Package Included)

1 * Piggy Bank

1 Screwdriver

1 * Instruction Manual

Preparation for Use]

1. Firstly, use the cross screwdriver to open the battom battery cover.
2. Then, install 3 “AA” batteries correctly according to the positive and negative tips ‘on the piggy bank. (We recommend using new batteries of the same type, avoid mixing old and new batteries. Do not use alkaline batteries.)
3. Finally, use the screwdriver to install the battery cover back on and start using.

(Operation Instruction]

Follow the steps below to use the piggy bank.

1. Enter the 4-digit password, if the password is correct, the green light will be an; if the password is incorrect, the red light will be on. The initial password is “0000”.
2. After entering the correct password, tum the knob clockwise to apen the door. If the door does not open within LO seconds, you will need to re-enter the password.
3. Once the door is open, if it remains open, it will emit a “DuDu” sound every 15 seconds and the red light will be on.
4. The banknote slot of the piggy bank has an automatic sensing function. When the banknotes are placed in the slot, the rollers inside will work and roll the banknote into the piggy bank, while a green light will be illuminated. (Note: neither the automatic sensing function nor the rollers will work when the door is open.)
5. There is a switch on the back of the docr which can be switched to “VOICE” mode or “BEEPS SOUND” mode. The “VOICE” mode is a speech pattem, when you enter a password number, you will be prompted with “Password please”; when you enter a wrong 4-digit password, you will be prompted with “Ah oh, sorry, please try again”. The “BEEPS SOUND” mode is a non-speech mode.

[Frequently Asked Questions)

1..Q What should | do if | forget the password?
A: Remove the battery and re-install it after 5-10 minutes, the password will be restored to the initial password “0000”.
2. Q How to change the password?
A: 1) Enter the current correct password and open the door of the piggy bank.
2) Hold down the “*” button, you will see the red light and green light flashing at the same time.
3) Enter the new 4-digit password within 10 seconds and press “#” to confirm the password, at this point the red and green lights will stop flashing.
4) Release the “** button and close the door to complete the password change.
5) Ifa new 4-digit password is not entered within 10 seconds, the password change procedure will be terminated.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>