RALPH LAUREN RL 2729 Barrett Mini Bed Light User Guide
- June 4, 2024
- ralph lauren
Table of Contents
ASSEMBLY INSTRUCTIONS
RL 2729 Barrett Mini Bed Light
Barrett Mini Bed Light
Item # RL 2729
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect items and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver Slotted Screwdriver
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate ( B ) from fixture by removing screws ( D ).
-
Install mounting plate ( B ) to the junction box and secure with mounting screws ( C ).
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut ( A ).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut ( A ).
-
Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut ( A ).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install fixture to mounting plate ( B ) and secure with screws ( D ).
-
Adjust shade up or down to desired position.
-
Dimmer Switch Operation: Turn knob ( E ) clockwise and adjust to desired brightness.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>