BELIMO Gas Monitoring Devices Accurate and Reliable Ventilation Installation Guide
- June 14, 2024
- BELIMO
Table of Contents
BELIMO Gas Monitoring Devices Accurate and Reliable Ventilation
Wiring Instructions
Important: All wiring must conform to local building codes, regulations and laws. If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be impaired.
Wiring
Notes
- Do not obstruct the monitor
- Do not ground the 24 V AC/DC
- When using multiple monitors:
- Maintain the same polarity (24 V AC/DC) for all devices
- CAN bus connection:
- Maintain the same polarity (CAN bus) for all devices
- Use 24 AWG twisted pair, low capacitance, shielded, communications cable
- Monitors must be connected in series
- Switch end of line (EOL) jumpers (for first and last units)
22Gxx-5A & C-22G-5A
22Gxx-5B & C-22G-5B
22Gxx-5C & C-22G-5C
Refer to Operation Manual section 3 for installation and section 4 for operation and parameters
Subject to change. © Belimo Aircontrols (USA), Inc.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>