circa LIGHTING RL 5332 Sable Large Chandelier Instruction Manual
- June 4, 2024
- circa LIGHTING
Table of Contents
Sable Large Chandelier
Item # RL 5332
ASSEMBLY INSTRUCTIONS
RALPH LAUREN
NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not insta itll. Retain all packaging material until installation is complete and approved.
-
Carefully remove all parts from the carton.
-
Feed the wire through the connection rod (K), and thread the connection rod (K) onto the top center hole of the light fixture by turning in a clockwise direction.
-
Remove canopy ring (F) from mounting loop (C) by turning in a clockwise direction.
-
Attach mounting strap (A) to the ceiling outlet box and secure with mounting screws (B).
-
Slide canopy ring (F) and canopy (E) on chain (G).
-
Remove the metal covers (J) from end links (D) by removing set screws (I), attach one of the end links (D) with the hanging loop (H) together, the other end link (D) with the mounting loop (C) together and secure by replacing metal covers (J) to end links. Tighten with set screws (I).
-
Feed wire through the chain (G), canopy ring (F), canopy (E) and mounting loop (C).
-
Attach the bare copper ground wire from the fixture to the ground junction box wire (usually green or copper), and fasten it together with a plastic wire connector. Tightly wrap the wire connector with electrical tape. Be sure no wire strands are exposed. IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.
-
Connect a neutral wire from the fixture (ribbed molded wire) to the neutral wire from the junction box (usually white) . Fasten both wires together with a plastic wire connector and tightly wrap the wire connector with electrical tape. Be sure no wire strands are exposed.
-
Connect the hot wire from the fixture (smooth wire) to the hot wire (usually black ) from the junction box. Fasten both together with a plastic wire connector and wrap the connection with electrical tape.
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL BE COMPROMISED. -
Tuck the wire connections neatly into the ceiling outlet box.
-
Slip canopy (E) to mounting strap (A) and secure with canopy ring (F).
-
Insert light bulbs (not included) into sockets.
-
Clip shades (L) onto the light bulbs.
-
Restore power and test fixture. Installation is complete.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>