MANOPOLA M002 Cheetah Mag User Manual
- June 15, 2024
- MANOPOLA
Table of Contents
User’s Manual
Gazelle Mag M002
Product Diagram
Product specifications
Product Name: Gazelle Mag
Model No.: M002
Capacity: 1OOOOmAh(37Wh)
USB-C Input: 5V=3A, 9V=2A, 12V=1.5A
USB-C Output: 5V=2A, 9V=2.22A, 12V=1.67A
Wireless Charging: 5W/ 7.5W/ 10W/ 15W
Size: 103.96817.8mm
Weight: 200g
Instructions for using the keys
Click to turn on the power;
Double-click to turn off the power;
Long press to open low current mode.
Charging M002
Use PD charger to charge M002 power Bank.
Recommendation: Use a charger with 18W or more to charge the battery packs.
Pass-through Charging
Discharging
Wireless Charging Charging with Cable
Bracket Use Mode
Packing List
Safety Precautions
- To preserve battery lifespan, use and recharge it once at least every 3months.
- Do not put the product near the magnetic card with magnetic stripe or chip (ID card, bank card, etc.) to avoid the invalidation of the magnetic card.
- Please keep the implanted medical device(pacemaker, implantable cochlea, etc.) at least 20cm directly away from the product to avoid potential interference with the medical device.
- Always keep this device dry and do not clean it with chemical agents.
- Do not crash, avoid dropping, disassemble, impale or put this device into humid conditions.
- Avoid extreme temperatures
- Do not use it to charge devices with incompatible current and voltage, which cause fire or other problems.
- The heating caused by wireless charging is anormal phenomenon(the ambient temperature will also affect the heating).
FAQ
When it's not charging for this device:
● Please check the cable, charger or adapter used are working. ● If not, please choose compatible components to charge it.
When it's not charging for the phone:
● Please make sure the power is on and the is power left in this device.
FCC statement:
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
device a distance of 0 cm surrounding the device and 0 cm above the top
surface of thedevicemust be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>