SOUNDSTREAM SSDSABRE BT Portable Speaker Instruction Manual

June 15, 2024
SoundStream

SOUNDSTREAM SSDSABRE BT Portable Speaker

NEDLANDS GROUP LHB-150W LED Linear High Bay

Quick Start Guide

Quick Start Guide

What’s in the Box

  • 1x Main Unit
  • 1x Type-C to C Charging Cable
    What’s in the Box

Solid White : Power ON
Blinking Red : Battery Low @ 20% with low battery warning tone Blinking White :

  • Slow Normal charging with 5V/3A
  • Fast blinking Fast charging with 15V/2A

Technical Specifications

Transducer| 64mm X 2 woofer , 20mm X 2 tweeter , 52 X 90mm X 2 Passive Radiator
---|---
Rated output Power (80W)|  25W X 2 Woofer , 15W X 2 tweeter
Frequency Response| 50Hz ~ 20kHz
Signal to Noise Ratio| >80dB
Battery Type| Li-ion polymer 44WH (eqv to 16.8V/2600mAh)
Battery Charge Time| 2 hours (15V/2A) support QC
Music Playtime| Up to 24hours (dependent on volume level and audio content)
USB Port| Type C
Bluetooth Version| v5.2
Bluetooth Profile| A2DP 1.3 , AVRCP 1.6
| 2400MHz ~ 2438.5 MHz
Bluetooth transmitter range| ≤ 10dBm (EIRP)
Bluetooth transmitter power| 2407 MHz ~2475MHz

Weight
Dimension

Dimension

Front

Back

Back

Front

Connecting Sabre with TWS

Connecting Sabre with TWS

  1. Connect main SABRE to smart phone.
  2. Press TWS on main SABRE to activate pairing mode(Blinking TWS light).
  3. Press TWS on secondary SABRE to activate search mode (Blinking TWS light).
  4. Pairing & Search will start. The successful tone will play, and blinking light will turn solid when both speakers are connected successfully.
  5. In event of unsuccessfully pairing, turn off both speaker for 10s and ON again.
    Repeat process 1 to start the TWS pairing. Pairing the speaker away from other electronics device that might cause interference.

WARNING

This speaker is waterproof with IP67 rating

Connecting Sabre with TWS

To protect battery lifespan, fully charge at least once every 3 months. Battery life will vary due to usage patterns and environmental conditions.

When using an external adapter, the output voltage/current of the external adapter should not exceed 15V/2A.

Chemicals, salt or “foreign particles” in the water or sea can damage the waterproof seal or  corrodes the connector surface over time if not rinsed off after use. After a liquid spill or rinse, it is important not to charge your speaker until it is completely dry and clean. Charging when wet might damage your speaker and cause electric shock.

Do not expose Soundstream Sabre to liquids without removing cable connection. Do not expose Soundstream Sabre to water while charging.
It may result in permanent damage to the speaker or power source.

Waranty Registration

QR Code

Model : SABRE
COLOR : LUNAR DUST
SERIAL NO : A5P/1234567

FAQ

QR Code

FCC Statement

  1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
  2. This device may not cause harmful interference.
  3. This device must accept any interference received, including interference that may cause undesired operation.
  4. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

SoundStream User Manuals

Related Manuals