Swiss Madison TT-5 Two Piece Toilet Installation Guide
- June 15, 2024
- Swiss Madison
Table of Contents
Swiss Madison TT-5 Two Piece Toilet
PRIOR TO INSTALLATION:
- Inspect toilet to ensure no damages have occurred while in shipping.
- Please compare parts with package list. If anyone is damage or missing, please contact us. We will replace new one for you.
- Observe all plumbing and building codes in accordance with your state and local requirements.
- All dimensions are nominal! Be sure to measure your toilet prior to installation.
- The step-by-step guidelines in the installation instructions are a general reference. Should there be any discrepancies, Swiss Madison cannot be held liable. It is recommended to install all Swiss Madison products by hiring a licensed professional.
- Read installation and maintenance instructions thoroughly before installing. Be sure to use proper tools and always wear proper personal safety accessories for your protection.
- Two people are recommended to handle and install this product as it is fragile.
- Fill valve has been factory-tightened to design specifications. If re-tightening is required, use a wrench a tighten one turn past finger tight.
- Make sure the supply pressure is a minimum of 35 psi (2.5kg/cm³), the toilet will not function properly without minimum water pressure.
- If you encounter any installation issues, please contact us at kilitde980@outlook.com, and our team of experts will be available to assist you.
PRODUCT SIZE
PARTS LIST
-
Bowl
-
Tank
-
Flush Lever
-
Fill Valve (Pre-installation)
-
Flush Valve (Pre-installation)
-
Tank To Bowl Gasket
-
Tank-To-Bowl Screws And Nut
-
Slow Close Seat (include screws and nuts）
-
Wax Ring
-
Bolt Caps (2)
-
Bowl-To-Floor Screws And Nuts
INSTALLATION INSTRUCTIONS
BACK-TO-BACK INSTALLATION
Depending upon your plumbing and venting conditions, the flow from the
toilet in a back-to-back installation may create a vacuum on the system and
draw water from the opposing bowl. The National Standards Plumbing Code
prohibits the use of a cross fitting for drainage as throw over is possible.
The code does approve a directional “Y” style fitting with proper venting to
direct the water downward and away from the other toilet.
Recommended fitting type for back-to-back installations.
WARNING: Overtightening of water supply line nuts could result in
breakage and potential flooding. If the connection leaks after hand
tightening, replace the supply line.
Do not use any type of sealant on the water supply connection. Use of
plumber’s putty, pipe dope, or any other type of sealant will void the
warranty
TOILET SEAT INSTALLATION
WARNING:
The load capacity for magnet holder and hook is approximately 3 lbs.
Please avoid hiding and scratching the protective layer on the surface.
If you require technical support or in the unlikely event that your purchase
is faulty please EMAIL US for immediate assistance. Faulty product claims made
within the 2 year warranty period will be replaced free of charge.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>