Add On ACCESSORIES GL1800 2018 Mirror Lights with DRL and Sequential Turn Signals Instruction Manual

Add On ACCESSORIES GL1800 2018 Mirror Lights with DRL and Sequential Turn

Signals

Product Information

Product Name: Part 45-1245 GL1800 2018+ Mirror Lights w/DRL  & Sequential Turn Signal
Manufacturer : Unknown
Model : GL1800 2018+
Compatibility : Compatible with GL1800 motorcycles manufactured in 2018 or later

Product Usage Instructions

1. Read the instructions thoroughly before starting the installation process.
2. It is recommended to have a qualified mechanic install these lights to prevent damage to the lights and motorcycle.
3. Begin by removing the 5mm Allen screw and arm panel shown in Figure 1.
4. Remove the mirror assembly by removing the two support bolts as shown in Figure 2.
5. Disconnect the electrical connection.
6. To remove the rearview mirror glass, pull out the bottom of the mirror glass to release the lower tabs. After the lower tabs have been released, push up on the bottom of the mirror glass to release the upper tabs. Refer to Figure 3.
7. Remove the two 4mm tapping screws and trim clip to remove the mirror panel.
8. Remove three 5mm tapping screws to release the turn signal assembly and mirror cover.
9. Remove the OEM turn signal assembly. Refer to Figure 3.
10. Install the new turn signal assembly in reverse order, replacing the OEM part.

Note : Figures mentioned in the instructions can be found in the user manual or product documentation provided by the manufacturer.

If you have any further questions or concerns, please contact the manufacturer at: 133 Gold St, Worcester, MA 01608
Phone : 508-791-7552
Fax : 800-821-9861
Email : info@addonaccessories.net

MOUNTING INSTRUCTIONS

Part 45-1245
GL1800 2018+ Mirror Lights w/DRL & Sequential Turn Signal
Read the instructions thoroughly before installing. There are several YouTube videos of this procedure.

Note : Recommended that these lights be installed by a qualified mechanic to prevent damage to the lights and motorcycle.

1. Remove 5mm Allen screw and arm panel shown in Figure 1.
2. Remove mirror assembly by removing the two support bolts as shown in figure 2.
3. Disconnect electrical connection.
4. Remove the rearview mirror glass by pulling out on bottom of the mirror glass to release the lower tabs. After the lower tabs have been released, push up on the bottom of the mirror glass to release the upper tabs. Figure 3.
5. Remove two 4mm tapping screws and trim clip, and remove the mirror panel. Remove three 5mm tapping screws to release the turn signal assembly and mirror cover. Remove OEM turn signal assembly. Figure 3.
6. Install in reverse order with new turn signal assembly, replacing OEM part.

133 Gold St, Worcester, MA 01608 508-791-7552 800-821-9861 fax 508-793-2919 email: info@addonaccessories.net

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>