TeachLogic WC-400 Wall Mount Installation Guide
- June 13, 2024
- TeachLogic
Table of Contents
Installation Instructions: WC-400 Wall Cabinet
Considerations for Location:
- Convenience of use
- Proximity to auxiliary multimedia equipment
- Proximity to electrical outlet
- Routing of speaker wires and sensor cable
List of Materials:
- Assembled wall mount cabinet (WC-400)
- Template for screw mounting location
- 4 ea. Self drilling drywall anchors with screws
- Tape template on wall and ensure that it’s level.
- Install drywall anchors (4) and screws (4). Tighten screws within 1/16″ of anchor.
- Position cabinet and slide onto screws. Tighten screws if required.
- Place the amplifier power supply into the cabinet. Route plug through bottom hole.
- Place power supply in holding slot inside of cabinet.
- If external, route auxiliary cables (not provided) up through bottom.
- Plug in microphone charger power supply into AC outlet, then route charger cable up through bottom hole. Option B: Some TeachLogic amplifiers have a 5V USB port to accept mic charger cable.
- Plug in speaker connectors, sensor cable, power cable and auxiliary cables.
- Carefully slide amplifier into cabinet making sure cables aren’t smashed or disconnected.
- Plug charger cable into charger and place charger on cover.
- Wire tie cables or install in wire-mold for tidy installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>