F F PP-1P Pico Miniature Electromagnetic Relay Instruction Manual
- June 13, 2024
- F F
Table of Contents
F F PP-1P Pico Miniature Electromagnetic Relay Instruction Manual
Purpose
Electromagnetic relay in housing for direct installation in flush- -mounted �60 box.
Functioning
Applying the supply voltage to terminals 1-3 will switch the relay on (closing
the contact between terminals 5-6).
After switching off, the contact between terminals 4-5 is closed.
The relay coil is supplied with 230 V, the relay contacts are galvanically
separated from the relay coil supply.
Mounting
- Disconnect the power supply.
- Install the relay in the flush-mounted box.
- Connect the power supply: N to terminal 3; L to terminal 1 or 2.
- Connect the power supply circuit of the controlled consumer via contacts 5-6 when using the NO (normally open) contact or 4-5 when using the NC (normally closed) contact.
For the same power source for relay and controlled receiver can perform a „bridge” between the feed point 2 and relay COM contact (terminal 5).
Wiring diagram
PP-1P Pico is compatible with backlit buttons.
- L power supply (terminals connected internally)
- N power supply
- NC contact (normally closed)
- COM contact (common)
- NO contact (normally open)
Technical data
power supply 100÷265 V AC
contact 1×NO/NC
maximum load current (AC-1) 16 A, 250 V AC
usage category AC-7a
activation time max 20 ms
deactivation time max 200 ms
mechanical durability min. 5×10⁶
power indication green LED
power consumption
standby 0.15 W
on 0.6 W
terminal 2.5 mm² screw terminals
tightening torque 0.4 Nm
working temperature – 25÷50°C
dimensions 35×36×19 mm
mounting in flush-mounted �60 box
ingress protection IP20
Power table
Table for loads supplied with 230 V AC:
-
tungsten 3000 W
-
halogen 2500 W
-
fluorescent 1500 W
-
energy-saving 750 W
-
LED 750 W
The above data are indicative and will heavily depend on the design of a
specific receiver (that is especially important for LED bulbs, energy-saving
lamps, electronic transformers and pulse power supply units), switching
frequency and operating conditions.
For more information visit: www.fif.com.pl.
Warranty
The F&F products are covered by a warranty of the 24 months from the date of purchase. Effective only with proof of purchase. Contact your dealer or directly with us.
CE declaration
F&F Fili powski L.P. declares that the device is in conformity with the
essential requirements of The Low Voltage Directive (LVD) 2014/35/EU and the
Electromagnetic Compatibility (EMC) Directive 2014/30/UE.
The CE Declaration of Conformity, along with the references to the standards
in relation to which conformity is declared, can be found at
www.fif.com.pl on the product.
Do not dispose of this device in the trash along with other waste!
According to the Law on Waste, electro coming from households free of charge
and can give any amount to up to that end point of collec� on, as well as to
store the occasion of the purchase of new equipment (in accordance with the
principle of old-for-new, regardless of brand). Electro thrown in the trash or
abandoned in nature, pose a threat to the environment and human health.
PP-1P Pico
Miniature
electromagnetic relay
F &F Filipowski L.P.
Konstantynowska 79/81, 95-200 Pabianice, POLAND
phone/fax (+48 42) 215 23 83 / (+48 42) 227 09 71
www.fif.com.pl; e-mail:
biuro@fif.com.pl
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>