Tsong HD03R Microwave Motion Sensor Remote For Dimmable Sensors With Memory Function User Guide
- June 13, 2024
- Tsong
Table of Contents
Tsong HD03R Microwave Motion Sensor Remote For Dimmable Sensors With Memory Function
Over View
HD03R lnstruction
Memory & Apply Mode
-
Press “ON/OFF button” to turn on the light or off.
-
To reset the parameters, Please follow the steps as below:
Step 1 – Press ON, to turn on the light if it was off at the start.
Step 2 – Press “Start” to the well-setting sensor.
Step 3 – Press the button of Detection range, Hold time, Stand-by dimming level, Stand-by period and Daylight threshold one after the other in sequence.
Step 5 – Press “Memory” to memor;7e the settings.
Note: The interval of each parameter setting shall be controlled within 30s. -
To programme other lights in !he array that have simi!ar sensors to !he same programme.
Step 1 – Press “ON” to the second sensor
Step 2 – Press “Apply”
lsolated Setting Mode
- Press “ON/OFF button” to turn on the light or off. Press “Auto Mode”, the remote will activate settings that were saved last or remain at the factory default settings.
- To reset the parameters, Please follow !he steps as below:
Step 1 – Press ON, to turn on the light if it was off at the start.
Step 2- Press any button of “Auto Mode”, “Reset” , Test” and “Apply” to begin the sensor detection mode.
Step 3 – Press the button of Detection range, Hold time, Stand-by dimming level, Stand-by period and Daylight threshold one after the other in sequence.
Notes:
- Settings will be saved automatically and remain until you press reset again.
- Ught will flicker when setting each parameter.
