buzztv BT-250 Remote Control User Guide
- June 13, 2024
- buzztv
Table of Contents
BT-250 Remote Control
1 BT-250 Remote
2 BT-250 Remote – Learning Function
The learning function on the IR-200 remote is used to control your TV. You
will be able to control: Power ON/OFF, Volume and Input Source. To do this
you will need the factory remote control for your TV.
1. On the BT-250, press and hold
the TV POWER + TV SOURCE for
3 seconds. Once the blue light
turns on, release the buttons.
2. Press the learning key you would like to program (TV POWER/
SOURCE/ TV VOL+/ TV VOL-) and the blue light will start flashing.
The flashing blue light indicates the BT-250 is in learning mode.
1. On your BuzzTV device, navigate to Settings > Remotes & Accessories
toggle Bluetooth to ON. Then choose: Add Accessory.
2. On the BT-250, press and hold the VOL – & the OK
Button for 3 seconds. Once the red light starts flashing,
release the buttons.
3. Select “BuzzTV BT-250” on your BuzzTV Device.
4. You are now Bluetooth Paired. You can confirm this by looking for “BuzzTV
BT-250” under the Remotes and Accessories Menu.
3. Align your TV Remote and the BT-250 so that the front transmitters are
pointing at each other. They should be within 1 inch or 3 cm of each other.
4. Press the button that you want to learn on the original remote. After
receiving a learning function successfully, the red light on the BT- 250 will
blink 4 times.
5. To learn other keys, repeat Steps 2-4
6. After entering the learning mode, you can exit the learning
mode by short pressing the “TV POWER + TV SOURCE” keys.
3 BT-250 Remote – Bluetooth Pairing
-
On your BuzzTV device, navigate to Settings > Remotes & Accessories
toggle Bluetooth to ON. Then choose: Add Accessory.
-
On the BT-250, press and hold the VOL – & the OK
Button for 3 seconds. Once the red light starts flashing,
release the buttons. -
Select “BuzzTV BT-250” on your BuzzTV Device.
-
You are now Bluetooth Paired. You can confirm this by looking for “BuzzTV
BT-250” under the Remotes and Accessories Menu.
Note:
If you do not select the key within 15 seconds after entering the
learning state, it will automatically exit the learning state.
Please note not all TVs are compatible with source pairing
CEC settings to support the BT-250, your TV & your BuzzTV Box
If you were successful in TV source pairing the BT-250to your TV then
you need to make sure the CEC settings on both the TV and your
BuzzTV Box are enabled and in some cases in the correct HDMI port on
the TV, refer to your TV manual if needed. (Initially set to ON)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>