OLIGHT Swivel Pro COB Work Light User Manual
- June 13, 2024
- OLIGHT
Table of Contents
OLIGHT Swivel Pro COB Work Light User Manual
PRODUCT OVERVIEW
BATTERY LEVEL INDICATOR
CHARGING
- Before first use please fully charge the product.
- Connect the USB end of the Type-C to an external USB power source, then attach the other end of the cable to the charging port of the light (best charging efficiency with a 5V 2A USB power source).
- Battery capacity: 5200mAh
- Time to fully charge: About 3.5 Hours
-
DANGER
- DO NOT throw the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
WARNING
- Don’t leave the light in a car where inside of temperature may be over 60℃，or in similar places.
- Before long term storage, please fully charge the product.
- When the charging port is not in use, keep the port dust cover closed to prevent the entry of dust or other foreign matters.
- Please DO NOT place the product in a dusty environment, because dust may enter the switch and cause it to malfunction.
- Do not disassemble the product.
- Do not immerse the light in seawater or other corrosive media as it will damage the product.
- Please handle it with care to protect it from falling down.
- O NOT pull its clip hook excessively to avoid damaging the product.
-
NOTICE
- Please charge the product with a 15W or higher-capacity USB power adapter to achieve the fastest charging possible.
- lease keep the product away from radios to avoid causing noise or interference to the radio signals.
EXCLUSION CLAUSE
Olight is not liable for damages or injuries sustained resulting from the usage of the product inconsistent with the warnings in the manual.
HOW TO OPERATE
ON/OFF: Press the button to turn on the light. Press the button again after
the light has been on for 3 seconds or more to turn it off.
CHANGE BRIGHTNESS: Press the button quickly to change brightness.
TWO MODES:
MODE 1(CAMP LIGHT MODE): Medium→High→Low→Red Light→Flashing Red
Light→Off
MODE 2(FLASHLIGHT MODE): High→Low→Off
CHANGE MODES: While the light is on, press and hold the button for 1
second to exchange mode 1 and mode 2.
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>