sudio E3 True Wireless Earbuds User Guide
- June 13, 2024
- Sudio
Table of Contents
E3
Owner’s Manual
E3 True Wireless Earbuds
- To tum Voice Assistant on/off hold L side for 2 sec
- To turn ANC on/off hold R side for 2 sec
Included in the box:
- E3
- Charging cable
- Ear tip holder
- Warnings folder
- Owners Manual
Pairing to a device:
- Remove protective stickers
- Place earbuds in the charging case, close the lid
- Open the lid, connect to device
Playback operations:
:tap
: Tap 2x left
: Tap 2x right
Vol: Tap 3x right
Vol: Tap 3x left
Phone call operations
Accept calls: 1 tap
Hang up or reject calls: Hold button 2 seconds
Battery indication:
LED blinks amber light when low battery (0–25%), and white light between 26%-100%
Charging
Charge with USB-C. Amber/white
Light = charging.
White light = charged.
Factory reset:
- Put earbuds in case
- Hold button on case for 5 sec with lid open
- Light blink 2x
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: r2This device may not cause harmful
interference, and ) This device must accept any interference received,
including interference that may cause undesired operation. Warning: Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in o residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment and
receiver. connect the equipment into on outlet on a circuit different from
that to which the receiver is connected. Consult the dealer or an experienced
radio/TV technician for help.
RF warning statement The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition without
restriction.
Sudio Help Center