ITC 69231 LED Radiance Light Instruction Manual
- June 13, 2024
- ITC
Table of Contents
LED Radiance Light
Part#: 69231 & 69240
INSTALLATION INSTRUCTIONS
PARTS/TOOLS NEEDED:
| | |
---|---|---|---
Radiance Overhead Light| Wire Nuts
(Not Provided)| Power Drill w/Hole Saw Bit (Not Provided)| Mounting Screws
(Not Provided)
IMPORTANT SAFETY INSTRUCTIONS
READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- It is recommended that fuse protection be added to the positive (+) input.
LED Radiance Light
- Determine where your LED light fixture will be installed.
Once determined, drill a hole using a hole saw (see chart below for hole size requirement).
| Mounting Method | Cutout |
|---|---|
| 69231 | (81229) |
| 69240 | (81232) |
| 69926 |
-
Use the wiring diagram below to wire the light to the units power.
-
Installing the spring clip version: Push the clips on both sides of light up and slide housing and clips through hole.
Clips will snap down and hold the light in place. -
Installing the screw mount version: Remove cover by twisting counter clockwise. Mark location of screw holes and pre-drill. Screw in fixture and re-install cover by twisting clockwise.
-
Installing the leaf spring version: Push light in at an angle and press down on opposite side until light is firmly seated in hole.
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
For warranty information please visit www.itc-us.com/warranty-return-
policy
Revision Level D • 08/22/23
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>