ITC 69343 3.5 Inch Radiance Light Instruction Manual
- June 13, 2024
- ITC
Table of Contents
ITC 69343 3.5 Inch Radiance Light
Product Information
The RadianceTM Light is a type of overhead light designed for installation in various settings. It is identified by the part number 69343.
Parts/Tools Needed:
- Radiance Overhead Light
- Butt Splice Connectors (not provided)
- Power Drill w/ Hole Saw Bit
Installation Instructions
Before installing the Radiance Light, please read and follow the safety instructions provided below.
Safety Instructions:
- Determine the installation location and drill a hole.
- Install and test the light.
Mounting Method:
The Radiance Light can be mounted using the Leaf Spring/Spring Screw method.
Cutout:
The cutout required for installation is 2 inches by 2 inches.
Wiring Diagram:
Refer to the wiring diagram below to properly wire the light to the unit’s power:
| Incoming 12V DC Power | Overhead Light |
|---|---|
| Black (-) | White (-) |
| 12V DC (+) | Black (+) |
| Incoming 12V DC Power | |
| Black (-) | |
| Fuse 12V DC (+) | |
| RGBW Controller | |
| Black (+) | White (W) |
| Green (G) | Red (R) |
| Blue (B) |
If you have any further questions or need assistance, please contact us at:
3030 Corporate Grove Dr. Hudsonville, MI 49426
Phone: 616.396.1355
Website: itc-us.com
Product Usage Instructions
- Determine the desired installation location for the Radiance Light.
- Using a power drill with a hole saw bit, drill a hole in the chosen location according to the specified cutout dimensions (2 inches by 2 inches).
- Ensure that the power is turned off before proceeding with the wiring process.
- Refer to the provided wiring diagram to properly connect the wires of the Radiance Light to the unit’s power.
- Make sure to connect the black (-) wire of the incoming 12V DC power to the white (-) wire of the overhead light, and the 12V DC (+) wire to the black (+) wire of the overhead light.
- If using an RGBW controller, connect the black (+) wire of the controller to the white (W) wire of the overhead light, the green (G) wire to the red (R) wire, and the blue (B) wire to the blue (B)wire.
- Once all the connections are made, turn on the power and test the Radiance Light to ensure it is functioning correctly.
PARTS/TOOLS NEEDED
Safety Instructions
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- Light is rated for interior installation only, do not install in wet locations.
- Operating Voltage: 10 – 14V DC
Mounting
-
Determine the installation location and drill a hole
Mounting Method| Cut- out
---|---
Leaf Spring/Spring| 2-⅝”
Screw| 2-½” -
Using the wiring diagram below to wire the light to the unit’s power
-
Install and test the light
3030 Corporate Grove Dr. Hudsonville, MI 49426
Phone : 616.396.1355
itc-us.com
For warranty information please visit www.itc-us.com/warranty-return-
policy
DOC #: 710-00077 • Rev B • 08/22/23
Part #: 69343
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>