1706408 Tundra with Tracks Deuce Instruction Manual
- June 13, 2024
- DEUCE
Table of Contents
1706408 Tundra with Tracks Deuce
INSTALLATION INSTRUCTIONS
-
Remove cargo rail end plugs: At the tailgate push in on the plug lock and at the same time push the end plug out of the track.
-
Remove tie downs: If tie downs are installed remove them from the cargo rail.
-
Install clamps: Slide the female side of clamp into the cargo rail. See step five to correctly arrange the order of the clamps and tie downs.
| Item | Part # | Description |
|---|---|---|
| 1. | 1706408 | 6408 MALE CLAMP |
| 2. | 1703889 | FEMALE CLAMP |
| 3. | 1701208 | CAP SCREW 5/16” X 1 1/4” |
| 4. | 1700428 | FLAT WASHER 5/16” |
-
Install clamps in cargo rail as shown below: After clamps and tie down are installed replace the cargo rail end plugs. Leave clamps loose for now. Repeat steps 1 through 4 for the passenger side clamp installation.
-
-
Installing Front Tie Downs: The tie downs will not fit under the underbody rails and will need to go on the bulkhead track at the front of the box.
-
Installing Front Tie Downs: The tie downs will not fit under the underbody rails and will need to go on the bulkhead track at the front of the box.
-
Install rear rail: With the underbody rails installed, position the rear rail along the inside edge of the truck box. Slide the rail forward so it is touching end to end with the underbody rail. Tighten clamps against the rail.
-
The Deuce rail will be positioned at this height with seal compressed.
Tighten clamp assemblies securely on side rails before driving vehicle.
Customer Support
by TruXedo, Inc.
2209 Kellen Gross Dr., Yankton, SD 57078
Phone: 877- 878-9336 • Fax:
605-664-9304
www.truxedo.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>