JBL WIND3 FM Bluetooth Handlebar Speaker User Guide
- June 4, 2024
- JBL
Table of Contents
JBL WIND3 FM Bluetooth Handlebar Speaker
Bicycle Mount
- included the Install onto bracket mounting .handlebars bicycle
- Dock the undock/ them into speaker bracket mounting effortlessly
WHAT’S IN THE BOX
BUTTONS
- long press to switch EQ between ‘Sport’ and ‘Bass’ mode
Bluetooth pairing
FM RADIO
- Source Switch to FM mode
- TUNE DOWN / TUNE-UP:
Press 1x to tune down/up by step manually Press 2x to tune to the
previous/next preset station
AUTO SCAN:
Long press to search for and tune to the previous/next available station
automatically
TF / AUX-IN
Charging
WATERPROOF DUSTPROOF IP67
TECH SPEC
- Transducer: 43 mm 47 mm/1.5″
- Output power: 5W RMS
- Frequency response: 110 Hz-20 kHz
- Signal-to-noise ratio: 85 dB
- Battery capacity: 1050 mAh
- Battery charge time: 2.5 hours (5V=1A)
- Music play time: up to 5 hours (dependent on volume level and audio content)
- Bluetooth version: 5.0
- Bluetooth profile: A2DP 1.3, AVRCP 1.6, HFP 1.7
- Bluetooth transmitter frequency range: 2400 MHz-2483.5 MHz
- Bluetooth transmitter power: <5 dBm (EIRP)
- Bluetooth transmitter modulation: GFSK, T/4 OPSK, 80PSK
- FM Tuning range: 87.5 MHz-108 MHz (varies by country)
- Dimensions (Wx HxD): 90 mm x 73.2 mm x 35.8 mm
- Weight: 0.230 kg
- Maximum operation temperature: 45°C
Warning
To protect battery lifespan, fully charge at least once every 3 months. Battery life will vary due to usage patterns and environmental conditions. Do not expose the JBL Wind 3 to liquids without removing the cable connection. Do not expose JBL Wind 3 to water while charging. It may result in permanent damage to the speaker or power source. Chemicals, salt, or “foreign particles” in your pool or the ocean can damage the waterproof seals or harm the connector surface over time if not rinsed off after use. After a liquid spill or rinse, do not charge your speaker until it’s completely dry and clean. Charging when wet might damage your speaker. When using an external adapter, the output voltage/ current of the external adapter should not exceed 5V/3A.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>