ROLL-BAR Forever Wave Roll Bar Sleeve Mount Instructions
- June 13, 2024
- ROLL-BAR
Table of Contents
Instructions
Forever Wave Roll Bar Sleeve Mount
ROLL-BAR
-
Put the hose clamps through the holes in the roll-bar mount (Bottle must be upright).
Wrap the hose clamps around your roll-bar.
Tighten the hose clamps using a 5/16” socket or a flathead screwdriver.
HOSE -
Connect the hose to the bottle by pressing the hose side (Male) to the bottle side (Female).
Disconnect the two CPC’s by pressing on the gray tab.
DOCK -
Position the Dock on the roll-bar within arms reach, while seated in the vehicle.
Secure using the provided hook and loop straps. Remember to Dock the bite valve when not in use.
SUCURE -
Using the provided hook and loop straps, secure the length of hose to your roll-bar.
Do not over-tighten the straps as it will disrupt the flow of fluid.
DISCONNECT
Disconnect the CPC connectors by pressing the gray tab.
Pull the red handle on the Bottle mount, tilt the Bottle towards you, and lift
the Bottle up and away.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>