HAMPTON PRODUCTS V150 Heavy Duty Single Pneumatic Closer Kit Installation Guide

: June 13, 2024
: HAMPTON PRODUCTS

Table of Contents

HAMPTON PRODUCTS V150 Heavy Duty Single Pneumatic Closer Kit
Product Information:
Product Usage Instructions
INSTALLATION INSTRUCTIONS
FULL ONE YEAR WARRANTY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

HAMPTON PRODUCTS V150 Heavy Duty Single Pneumatic Closer Kit

HAMPTON-PRODUCTS-V150-Heavy-Duty-Single-Pneumatic-Closer Kit-
PRODUCT

Product Information:

Product Models: V150, V820, US920, V920, V1020

Product Usage Instructions

Jamb Bracket Support de Chambranle / Soporte para Jamba:
- Use this bracket to support the door jamb.
- Dimensions: 1/4 inch (6.35 mm)
Short Connecting Pin / Goupille de Raccordement Courte / Lug Ergot Oreja:
- Use this pin to connect various components.
Door Jamb / Chambranle de Porte / Jamba de la Puerta:
- This is the frame around the door.
- Use the long connecting pin to secure the door jamb.
Closer Tube / Tube de Ferme-Porte / Tubo de Cerrador de Puerta:
- This tube is used for the door closer mechanism.
- There are rear and front holes for installation.
Door Panel / Panneau de Porte / Panel de Puerta:
- This is the main panel of the door.

INSTALLATION INSTRUCTIONS

This closer may be installed at any desired location on the door, however the recommended location is at the top of the door, or on the mullion strip near the center of the door.

Note: Before installation, check door to see that it closes freely.

Step 1 – On hinge side of door, at the desired height, fasten the jamb bracket to the door jamb with the (4) long screws. The open side of the bracket should be 1/4″ from door as shown. (FIG. A)
Step 2 – Slide hold-open washer on rod. Using short connecting pin, connect closer to jamb bracket. Hold-open washer should be positioned over lugs against closer tube as shown. (FIG.B) This will give proper tension for installation. (Do not change until installation is completed).
Step 3 – Attach door bracket to FRONT hole of the closer with long connecting pin. (FIG. C) With door tightly closed, hold closer and door bracket against door in level position, mark and drill (2) 1/8″ pilot holes. CAUTION: Do not drill holes all the way through the door. Fasten door bracket to door as shown with short screws. Open door and move hold-open washer back of lugs on rod. Closer is now ready to operate.
Speed Adjustment – To regulate closing speed of door, turn adjusting screw counter-clockwise for faster and clockwise for slower. (FIG. D)
Snap Action Closing – Installed as directed above, the closing speed of door will accelerate in the last few inches of travel. If a smoother, quieter closing action is desired, hold door open about 8″ with hold-open washer, remove the long connecting pin and relocate closer in rear hole.

HAMPTON-PRODUCTS-V150-Heavy-Duty-Single-Pneumatic-Closer-Kit-
FIG-1

FULL ONE YEAR WARRANTY

For warranty details or to make a warranty claim for repair or replacement, please visit www.hampton.care or contact Hampton Care at 1-800-562-5625. Return of defective product and receipt may be required for warranty claims.