avide LED Floor Lamp Remo 9W User Manual
- June 13, 2024
- Avide
Table of Contents
avide LED Floor Lamp Remo 9W User Manual
Product Using Instruction
Before using the product for the first time, please read the instructions and retain them for later reference.
Warnings:
Make sure that the appliance has not damaged during transport! ï Do not
disassemble the product at home. ï To avoid damages, please do not overtighten
the adjustable parts of the lamp. ï Please do not use the lamp at high
temperatures or in high humidity environments. The lamp can only be used in
dry, indoor conditions! ï Do not stare into the light of the LED.
In the following cases, please unplug the power cord immediately and do not use the lamp: The power cord or the connector has been damaged. If the power cable becomes damaged, it should be replaced with cables, obtained directly from the manufacturer or its service facility. ï The lamp base is humid or wet. ï In case of any damage of any part of the lamp. ï The lamp smokes or sparks. ï Flashing or failure of the LED light source.
- Before using, connect the connector of the supplied adapter to the lamp and the adapter to the network.
Assembly:
- Assemble the lamp from top to bottom. The power cord is in the tube. When connecting the parts, make sure that the cable is intact.
- To connect the tube elements, rotate them clockwise.
- Screw the connected tubes onto the lamp base.
- Connect the cable (at the bottom of the luminaire) to the adapter and then plug the adapter into the main.
- When everything is properly connected, the lamp is ready for use.
Pay attention to the polarity when replacing battery! • Do not use different kinds of batteries and/or used and new batteries together!
- Do not open, burn and short circuit the batteries! ï It is forbidden to charge the batteries which are not rechargeable! Risk of explosion!
Cleaning / Maintenance
The unit may require cleaning at least once a month, depending on the manner of use.
- Power off the luminaire before cleaning! 2.Use a slightly moistened cloth to clean the outer surface of the luminaire. Do not use any aggressive cleaners. Avoid getting water inside the product and on the electric components!
Lamp parts:
A. LED Light source
B. Lampneck
C. Control Panel
D. Main body
E. Base
F. Main cord
G. Adapter
H. IR Receiver
I. 10m timer indicator
J. 60s timer indicator
K. ON/OFF Button
L. Color temperature change
M. Brightness change
9W
in 100-240V out 10V(adapter)
60 PCS LED
3000 – 6000K
ALU, ABS, FE
220x220x1800mm
Remote:
- ON/OFF Button
- 60s timer
- 10m timer
- Increase brightness
- Decrease brightness
- Increase color temperature
- Decrease color temperature
- Night light function
- Brightness 20%
- Brightness 50%
- Brightness 100%
- Warm white mode
- Cold white mode
- Neutral white mode
Waste equipment must not be collected separately or disposed of with household waste because it may contain components hazardous to the environment or health. Used or waste equipment may be dropped off free of charge at the point of sale, or at any distributor which sells equipment of identical nature and function. Dispose of product at a facility specializing in the collection of electronic waste. By doing so, you will protect the environment as well as the health of others and yourself. If you have any questions, contact the local waste management organization. We shall undertake the tasks pertinent to the manufacturer as prescribed in the relevant regulations and shall bear any associated costs arising
For technical or warranty support, please contact the authorised representative:
Bramcke GmbH
52353 Düren
An Gut Nazareth 18A
Germany
www.bramcke.de
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>