Sharp EL-330WB Basic Desktop Calculator Opration Manual

Sharp EL-330WB Basic Desktop Calculator

BEFORE USE

• Do not press too hard against the LCD panel because it contains glass.
• Never dispose of the battery in a fire.
• Keep the battery out of reach of children.
• Please press if you see no indication.
• This product, including accessories, may change due to upgrading without prior notice.
• Since this product is not waterproof, do not use it or store it where fluids, for example water, can splash onto it. Raindrops, water spray, juice, coffee, steam, perspiration, etc. will also cause malfunction.

SHARP will not be liable nor responsible for any incidental or consequential economic or property damage caused by misuse and/or malfunctions of this product and its peripherals, unless such liability is acknowledged by law.

SPECIFICATIONS

• Type: Electronic calculator
• Operating capacity:
  • EL-330W: 10 digits
  • EL-334W: 12 digits
• Power supply: Built-in solar cell and alkaline manganese (1.5V … (DC) LR44×1)
• Operating time: (varies according to use and other factors)
  • Approx. 24 months (with 1 hour of daily use, using the alkaline battery only)
• Automatic Power-off: Approx. 7 min.
• Operating temperature: 0°C – 40°C (32°F-104°F)
• Dimensions:
  • EL-330W:
  • 98 mm(W) × 153 mm(D) × 27.5 mm(H)
  • 3-27/32″(W) × 6-1/32″(D) × 1-3/32″(H)
  • EL-334W:
  • 112 mm(W) × 170 mm(D) × 14.3 mm(H)
  • 4-13/32″(W) × 6-11/16″(D) × 9/16″(H)
• Weight:
  • EL-330W: Approx. 120 g (0.27 lb)
  • EL-334W: Approx. 161 g (0.36 lb) (battery included)
• Accessories: Alkaline manganese battery (installed), Operation manual

KICKSTAND

BATTERY REPLACEMENT

OPERATIONS

1. Press C-CE twice to clear any residual values and calculation instructions in the calculator.

2. EL-330W:
   Upon starting the memory calculation, press CM to clear the memory.
   EL-334W:
   Before performing grand total (GT) memory calculation, press (GT) twice to clear the grand total memory
   contents.
   Upon starting the memory calculation, press CM to clear the memory.

3. For expressing calculation examples, only the symbols that are required for explanation are mentioned.

4. Example procedures are listed in the following manner unless otherwise specified.

5. The operations of multiple models are described in this manual. Therefore, the position of symbols in this manual may be different from your model.

COST / SELL / MARGIN CALCULATION /

• The entered value (enter value, then press COST, SELL, or MG ) will be kept in the buffer; re-entry will not be necessary when recalculating. The buffer contents will be cleared upon new entry, or when CA is pressed.

• Immediately after pressing C-CE, COST, SELL, or MG, the set value of cost price/selling price/margin can be verified by using the COST, SELL, or MGN key.

• Determine the cost price for a 30% margin when the selling price is set at $500.

  • Selling Price
  • Margin
  • Cost Price

• Entries in the order of “30 MGN 500 SELL, FIND, COST are also valid.

• Determine the selling price for a 30% margin when the cost price is set at $350.

  • Cost Price a Margin
  • Selling Price

Note:

• Performing a selling price calculation will result in an error if the margin is set to 100%.

• Press c-CE to clear the error.

• Entries in the order of “30 MGN, 350, COST, FIND, SELL are also valid.

• Determine the margin when the cost price is set at $350, and the selling price at $500.

  • Cost Price
  • Selling Price
  • Margin

• Also, obtain the margin when the cost price is set to $250.

• Entries in the order of “500  SELL 350 COST FIND MGN are also valid.

HOW TO PERFORM BASIC CALCULATIONS

• In these display examples, symbols such as “=” and “+”, “–”, “×”, and “÷” which are visible on the actual display are omitted.

EL-334W:

If the value obtained by pressing = and % is other than 0, it is automatically added to the grand total memory, and the “G” symbol appears on the display. Note that the “G” symbol is not shown in this operational manual, except for in the grand total calculation display.

CALCULATING TAX

• To perform a tax calculation, first, it is absolutely necessary to set and check the tax rate. (The initial tax rate is 0.)

• A tax rate can be set (or changed) with a number containing up to four digits. (A decimal point is not regarded as a digit.)

• The set tax rate is retained until it is changed. However, the set tax rate may be changed or lost if the battery is consumed largely.

  • Confirming the tax rate. (0%)
• • Set a 5% tax rate. Calculate the tax on $800 and calculate the total Including tax.
• • Perform two calculations using $84 and $52.5, both of which already include tax. (tax rate: 5%)
    • Calculate the tax on the total and the total without tax.

PERFORMING A MULTIPLE CONVERSION

• Before performing Multiple Conversion, set and confirm a conversion rate first. (The initial conversion rate is “0”.)

• A conversion rate can be set (or changed) using 6 digits. (A decimal point does not count as 1 digit.)

• Once set, the conversion rate is memorized until it is changed. However, the conversion rate may change because of battery replacement or consumption, etc.

  • Confirm the conversion rate (0).

• Set up a conversion rate (i.e. 1 dollar = 123.45 yen). Converting 120 dollars to the yen (Conversion rate: 1 dollar = 123.45)

• Set a conversion rate of 1 m = 39.3701 inches, and convert 472.4412 inches to meters.

In U.S.A.:

LIMITED WARRANTY

VICTOR TECHNOLOGY LLC warrants to the first consumer purchaser that this Sharp brand product (the “Product*), when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective Product or part thereof with a new or remanufactured equivalent at no charge to the purchaser for parts or labor for the period(s) set forth below.

This warranty does not apply to any appearance items of the Product nor to the additional excluded item(s) set forth below nor to any Product the exterior of which has been damaged or defaced, which has been subjected to improper voltage or other misuse, abnormal service or handling, or which has been altered or modified in design or construction.

In order to enforce the rights under this limited warranty, the purchaser should follow the steps set forth below and provide proof of purchase to the servicer.

The limited warranty described herein is in addition to whatever implied warranties may be granted to purchasers by law. ALL IMPLIED WARRANTIES INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR USE ARE LIMITED TO THE PERIOD(S) FROM THE DATE OF PURCHASE SET FORTH BELOW. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.

Neither the sales personnel of the seller nor any other person is authorized to make any warranties other than those described herein or to extend the duration of any warranties beyond the time period described herein on behalf of Victor.

The warranties described herein shall be the sole and exclusive warranties granted by Victor and shall be the sole and exclusive remedy available to the purchaser. Correction of defects, in the manner and for the period of time described herein, shall constitute complete fulfillment of all liabilities and responsibilities of Victor to the purchaser with respect to the Product and shall constitute full satisfaction of all claims, whether based on contract, negligence, strict liability or otherwise. In no event shall Victor be liable, or in any way responsible, for any damages or defects in the Product which were caused by repairs or attempted repairs performed by anyone other than an authorized servicer. Nor shall Victor be liable or in any way responsible for any incidental or consequential economic or property damage. Some states do not allow the exclusion of incidental or consequential damages, so the above exclusion may not apply to you.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY ALSO HAVE OTHER RIGHTS THAT VARY FROM STATE TO STATE.

Your Product:

• Warranty Period for this Electronic Calculator
  • One (1) year of parts and labor from the date of purchase.

Product: Additional Items Excluded from Warranty Coverage:

• Any consumable items such as paper, maintenance cartridges, ink cartridges supplied with the Product or to any equipment or any hardware, software, firmware, fluorescent lamp, power cords, covers, rubber parts, or peripherals other than the Product.

How to Obtain Service:

• Call Victor Technology LLC toll-free at 1-844-578-1637 or email SharpService@victortech.com.
• You may be asked to ship your Product to Victor Technology LLC for repair. Be sure to have proof of purchase available.
• If you ship or mail the Product, be sure it is packaged carefully.

Frequently Asked Questions

What should I do if I need to ship the calculator for repair?

If you need to ship the product for repair, be sure to package it carefully to prevent damage during shipping.

Is there a customer support hotline for inquiries or issues with the calculator?

Can I perform percentage calculations on this calculator?

Yes, this calculator allows you to perform percentage calculations using the '%' key.

How can I clear any errors or incorrect entries while using the calculator?

You can press C-CE to clear any errors or incorrect entries and start fresh with your calculations.

What do I do if I accidentally press the wrong function key during a calculation?

If you accidentally press the wrong function key during a calculation, simply press C-CE to clear the input and re-enter the correct values and function.

Can I calculate percentage margins for cost and selling prices with this calculator?

Yes, you can calculate percentage margins for cost and selling prices by entering the values and using the MG, COST, and SELL keys.

Does this calculator have a grand total memory feature?

Yes, the calculator features a grand total memory for performing calculations that involve totals. The 'G' symbol will appear on the display when the memory contains a value other than 0.

What kind of calculations can I perform with the COST, SELL, and MG keys?

You can use these keys to perform cost, selling price, and margin calculations. The calculator stores the entered value, and re-entry is not necessary for recalculating. Clear the buffer by entering a new value or pressing CA.

Can I set a custom tax rate with more than one decimal point?

The tax rate can be set or changed with a number containing up to four digits, but decimal points are not regarded as digits. Therefore, you cannot set a tax rate with more than one decimal point.

Is it possible to change the set tax rate on the calculator?

Yes, you can change the set tax rate as needed. Simply input the new tax rate, and the calculator will use that rate for subsequent calculations.

How does the calculator handle tax calculations for amounts that already include tax?

The calculator allows you to calculate tax for amounts that already include tax. To do this, enter the amount, press Tax-, and it will compute the tax amount.

Can I calculate a total including tax on an amount with a set tax rate?

Yes, you can calculate the total amount, including tax, on an input amount by pressing Tax+.

Video- Product Overview

Download This PDF Link: Sharp EL-330WB Basic Desktop Calculator Opration Manual

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>