Calculated Industries 8110 Center Mark Magnetic Drywall Locator Tool User Guide
- June 13, 2024
- CALCULATED INDUSTRIES
Table of Contents
USER MANUAL
CENTER MARK™
WITH MAGNETIC POWER
US PATENT #6,708421
8110 Center Mark Magnetic Drywall Locator Tool
Five Easy Steps to Perfect Cutouts for Recessed Lighting Fixtures!
Use it for 4″, 5” and 6” Recessed Lighting Fixtures
Step 1 – Screw Center Mark Target into the light bulb socket inside the recessed light fixture. Telescoping magnet should extend below ceiling level.
Step 2 – Cover the recessed light fixture with the drywall. The Center Mark
target automatically adjusts upward so that the magnet rests directly on the
ceiling surface in the center of the light fixture. Position the drywall and
fasten it with enough drywall screws to make it secure.
Step 3 – With the magnet face on the Center Mark Locator facing up, pass the
Locator across the area where Target is located. Find the Target and let the
Locator SNAP into place.
Step 4 – With your spiral saw, cut from the Locator outward until you make contact with the inside wall of the light fixture. Jump the entire bit to the outside of the fixture (about 1/4 inch more than the thickness of the fixture) and start your cut on the outside of the light fixture. Move the tool slowly, with inward pressure, counter clockwise 360 degrees around the fixture
Step 5 – Remove the drywall cutout and the Center Mark Target.
Finish fastening the drywall. And you’re done!
1.888.610.7664
www.calcert.com
sales@calcert.com