ELEKTRA BECKUM BS 200 W Belt Sanding Machine Instruction Manual
- June 13, 2024
- ELEKTRA BECKUM
Table of Contents
Ein Unternehmen der Metabo – Grouppe
Assembly Instructions Belt Sanding Machines
BS 200 W/BS 200 D
BS 200 W Belt Sanding Machine
Attention! Carefully read through these instructions prior to installation and commissioning.
To facilitate space saving packing, the linishing arm must be installed by the
customer. Please follow the instructions given below:
Put the pre-assembled linishing arm (1 – 17) on the motor and tighten.
Place narrow reducing bush (27), cup wheel (18) and wide reducing bush (28) on
the motor shaft and secure with a hexagon nut M 12.
Screw ball knob with threaded bolt (24) into the bracket (5), then attach the
starknob screw (22) with the thin type knurled thumb nut M 8 (23).
– Do not yet fully tighten the knurled thumb nut –
Observe the running direction, indicated by arrows on the inside of the
sanding belt, when fitting a sanding belt (see illustration).
By pushing the ball knob (24) in, the centre distance between the axis is
lessened for fitting the sanding belt (25) on the two wheels (9 + 16).
Adjust height of the tool support (15) against the sanding belt (25) and
secure in position.
By turning the starknob screw (22) and moving the sanding belt (25) by hand at
the same time, the sanding belt is aligned until is runs straight on the
wheels.
Final alignment is made by switching the machine on and readjusting the
starknob screw (22). Once the sanding belt
(25) runs straight on the wheels, without wandering to either side, the thin
type knurled thumb nut (23) is fully tightened.
To install the wheel cover (26) remove the 5 screw from the support (15), put
the wheel cover in place and fasten with the 5 screws.
Metabo UK Ltd., 25 Majestic Road, GB-SO 16 OYT
Tel.: +44-2380-732 000, Fax: +44-2380-747 500
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>