SHENZHEN TWS-BT-VX Wireless Bluetooth Earphone User Manual
- June 4, 2024
- Shenzhen
Table of Contents
SHENZHEN TWS-BT-VX Wireless Bluetooth Earphone User Manual
Thanks for using Onestyle wireless Bluetooth Earphone( TWS-BT-VX). For a good
user experience, please read the manual carefully before using the products.
Notice: To avoid unnecessary troubles, please do not disassemble product
by yourself, and please use the standard charger to charge.
Product overview
First time using
- Tear off the insulating film.
- Put back these earbuds to charging case for charging
- Take out from case, the indicator will turn to Red and Blue alternately. Warm notice: If the earbuds are not turned on or there is no sound come out, please put them back in the charging case again to make sure that they are in the charging state before taking them out for use (red/blue light flash alternately)
- The indicator of right earbud will go off and left will flash red and blue light alternately.(In pairing mode)
- Turn on the Bluetooth function on your phone and search for ETWS-BT VA and connect it. After connected, earbuds has no light.
Button control
Take-out from case OR Press and hold for S seconds.
When back into case OR No connection for 5 minutes OR Press and hold the touch button for 5s.
MAKING PHONE CALLS
Function | Operation |
---|---|
Answer the call | Click L/R earbud one time |
Hang up the call | Click L/R earbud one time |
Reject the call | Press L/R earbud 2 seconds |
LISTENING THE MUSIC
Function | Operation |
---|---|
Play the Music | Click L/R earbud one time |
Pause the music | Click L/R earbud one time |
Volume up | Click R earbuds 2 times |
Volume down | Click L earbuds 2 times |
Next song | Click R earbuds 3 times |
Last song | Click I. earbuds 3 times |
Earbuds indicator
Status: Indicators
Turn on: Red/blue light flash alternately
Turn off: Red Light flash for Three second
Searching mode: Left earbuds light flash red and Blue alternatively
Connected successfully: No light
Music play mode: No light
Charging case indicator
Status: Indicater
Charging To case: Orange indicater flashes
Full Battery: Orange indicator stay on
Charging for carbuds: Green indicator flashes
Low Battery: Orange indicator flashes
Packing details
2xFarbuds
1xCharge case
1xUsb charging cable
1xUser manual
1xWarranty card
EU Declaration of Conformity
CORN Technology GmbH, declare that the product Onestyle TWS-BT-VX radio
conforms to the following guidelines: Radio Equipment Directive (RED)
2014/53/EU, RoHS Directive 2011/65/EU and amendment Commission Delegated
Directive(EU)2015/863. The full text of the EU Declaration of Conformity is
available at the following Internet address:
www.corntechnology.com Manufactureed and
distributed by: Corn Technology Germany GmbH,Beyerbachstr.8,65830 Kfiftel
Tel : -I-49 (0) 6192-9623190
Correct disposal
This marking on the product, accessories indicates that the product and accessories must not be disposed of together with household waste
Copyright © 2020 Corn Tecnology Germany GmbH
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate
the receiving antenna. — Increase the separation between the equipment and
receiver. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.Consult the dealer or an experienced
radio/TV technician for help. The device has been evaluated to meet general RF
exposure requirement. The device can be used in portable exposure condition
without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>