Infinix X6833B Smartphone User Manual

Infinix X6833B Smartphone

Product Information

The Infinix X6833B is a mobile phone that features various components and modules. These include an LCD&CTP module, a front housing assembly, side key FPC, main FPC, camera modules, sensors, battery, waterproof stickers, speakers, motors, and more. The device also supports features like NFC and has a side fingerprint sensor. It operates on the Android operating system.

Explosion Diagram Specification:

1. LCD&CTP MOUDULE
2. RAD FILM F HSG
3. REC DECO
4. HEAT CON COPPER PIPE
5. FRONT HOUSING ASM
6. FRONT CAM RUBBER
7. SIDE KEY FPC
8. FRONT CAM FRAME
9. MAIN FPC
10. PA COP FOIL
11. 64M CAM COP FOIL
12. 64M BACK CAM
13. SENSOR RUBBER
14. COAXIA LINE
15. COPPER PIPE MYLAR
16. MAIN PCBA
17. BATTERY
18. 2M BACK CAM
19. 16M FRONT CAM
20. FRONT CAM RADIATOR FILM
21. 8W CAM FIXED FRAME
22. 8W BACK CAM
23. FINGERPRINT
24. SPK
25. SPK FRAME
26. MOTOR
27. WATERPROOF STICKER
28. SUB PCBA
29. MAIN WATERPROOF FRAME
30. MAIN WATERPROOF FRAME MYLAR
31. RECEIVER
32. 2M CAM RUBBER
33. MIDDLE FRAME RADIATOR FILM
34. NFC
35. MAIN PCBA RADIATOR FILM
36. CARD HOLDER
37. 2M CAM TRIM
38. 8W CAM RUBBER
39. FLASH LENS CAM TRIM
40. 2M LENS
41. 64M LENS
42. FLASH LENS LENS
43. 8W LENS
44.  EARJACK RUBBER
45. USB RUBBER
46. L2.0 SCREW
47. L2.5 SCREW
48. MID FRAME
49. L3.5 SCREW
50. BATTERY COVER

Know your phone:

1. Front camera
2. Volume + key
3. Volume – key
4. Power key & side fingerprint sensor
5. NFC

SIM/SD card installation:

1. Power off the mobile.
2. Refer to the user manual for SIM/SD card installation instructions.

Charging the phone:
You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone). It is recommended to use only INFINIX charger and cables, as other chargers or cables may damage the device and invalidate the phone warranty.

FCC Caution:
This device complies with Part 15 of the FCC Rules. It must not cause harmful interference and must accept any interference received. Any changes or modifications not approved by the responsible party could void the user’s authority to operate the equipment. The device also meets the government’s requirements for exposure to radio waves.

Operating System:
The Infinix X6833B operates on the Android operating system, which is a trademark of Google LLC.

Explosion diagram specification

Know your phone

1. Front camera
2. Volume + key
3. Volume – key
4. Power key & side fingerprint sensor
5. NFC

SIM/SD card installation

1. Power off mobile.
2. Refer to the following picture for SIM / SD card installation.

Charging the phone

You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone).
Use only INFINIX charger and cables. Other chargers or cables may damage the device. This will invalidate your  phone warranty.

FCC Caution

Labelling requirements.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Information to user.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.

FCC RF Exposure Information and Statement
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue.
Device types: X6833B ( FCC ID: 2AIZN-X6833B) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 1.156W/kg and when properly worn on the body is 1.136W/kg. This device was tested for typical body-worn operations with the back of the handset kept 10 mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 10 mm separation distance between the user’s body and the back of the handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that does not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided.

Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna. For DTS patents, see http://patents.dts.com. Manufactured under license from DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol together are registered trademarks or trademarks of DTS, Inc. in the United States and/or other countries. © DTS, Inc. All Rights Reserved.

Operating System： AndroidTM Android is a trademark of Google LLC.

References

• Patents - DTS

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>