Kuzco Lighting Alden EB49020-UNV Exterior Bollard LED Instruction Manual
- June 13, 2024
- Kuzco Lighting
Table of Contents
Kuzco Lighting Alden EB49020-UNV Exterior Bollard LED Instruction Manual
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all time during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
Please Note:
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required
- 120~277V input
- Remove fixture from its original package
- Provide means to bring supply wiring to bollard in accordance with local code before pouring concrete
- Secure anchor bolts (1c) to mounting guide plate (1e) with hex nuts and washers provided (1d) before concrete cures (See Illustration 1)
- After concrete is set, replace mounting guide plate (1e) with mounting base (2b), adjust mounting base to desired orientation and secure with hex nuts and washers (1d)
- Pull conduit through base plate to make proper electrical connection (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in hardware package, tie access wires to avoid contact with ground
- Align interior bump on fixture base (3a) with slot on mounting base (2b) (See Illustration 2), rotate to desired orientation, and secure fixture base (3a) to mounting base (2b) with screws (3b). Secure fixture head (1a) to fixture base (3a) with screws (2a)
Illustration
Mounting Guide Template
19054 28th Avenue Surrey, BC Canada V3Z 6M3 T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196 W: kuzcolighting.com 20230109
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>