BELMAX GD18040297 Qi Wireless Charger Instructions
- June 13, 2024
- BELMAX
Table of Contents
Qi Wireless Charger
Instructions
Description
Wireless charger for smartphones under the Ql-standard.
Easy to charge your phone without cables, just put your phone on the charging
plate.
Specifications
Input: According to the printing on the back of the charging plate.
Input: DC5V-2A
Output: DC5V-1A
Working Frequency: 110KHZ-220KHZ
Operating Temperature Range: -0~45°C
Storage Temperature Range: -10 ~50°C
Storage Humidity: 45% ~ 85% RH
Compatible with the Ql-standard.
Package contents
Wireless charging plate
Adapter or Power cable
Power supply
The charger is recommended to power by a qualified AC adapter.
Operation
Connect the wireless charger to an outlet such as a qualified AC adapter, then a Led light is lit. Put your phone on the charging plate and the battery starts to charge, the Ledlight blinks during charging. If the phone dessn’t start to charge,please try to reposition it.
FCC Warning
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user ‘s authority to
operate the equipment.
Refer to KDB 784748 Anner A section A.5:
(a) Max. Electric Field Emissions: 6 .06V/m Max.
Magnetic Field Emissions : 0.54A/m
(b) The maintenance of the system is the responsibility of the manufacturer.
(c) To prevent interference, the product should be as far away from devices
operating at the same frequency as possible.
FCC ID: 2BCYB-0003743