OLIGHT I3T EOS Ti Vertical Lines LED Flashlight User Manual
- June 13, 2024
- OLIGHT
Table of Contents
User Manual
( LIMITED EDITION )
Thank you for purchasing this Olight product. Please read this manual carefully before use and keep it for future reference!
IN THE BOX
|
---|---
i3T EOS Ti (Wertical Lines)| AAA Alkaline Battery( installed Inside the
Flashlight )
SPECIFICATIONS
| | |
---|---|---|---
HIGH| 180 lumens| 60m| 27min
LOW| 5 lumens| 12m| 16h
| | |
900cd| 1.5m| IPX8| 60m
LENGTH| | 89mm / 3.5in|
BEZEL DIAM.| | 15mm / 0.59in|
WEIGHT| | 51g /1.80oz (Including battery)|
*All above specifications are test results based on ANSI/NEMA FL1-2009 Standards.
INSULATING FILM
Before first use, unscrew the tailcap and remove the insulating film.
BATTERY INSTALLATION
If the battery needs to be replaced, make sure that the positive end of the
new battery faces the flashlight head when you put it in.
AVAILABLE BATTERIES
- 1x 1.5V AAA alkaline battery (included)
- 1x AAA lithium battery (compatible)
- 1x AAA NiMH battery (compatible)
DANGER
- DO NOT shine the light directly into human eyes. This may Cause temporary blindness, or permanent damage to the eyes.
- D0 NOT cover the light head when the flashlight is on, place the flashlight head on the ground. The radiation energy of the flashlight may cause damage to the flashlight itself, or even result in burning to other materials.
- DO NOT use batteries other than the ones mentioned in the “available batteries”, especially rechargeable lithium batteries, otherwise it could lead to the damage of the flashlight, or unexpected danger.
WARHING
Keep out of reach of children.
If the light is about to be put aside for a long time or be transported,
please unscrew the tailcap and remove the battery to cut off the circuit.
NOTICE
Ensure battery is inserted with the positive (+) end pointing to the head of
the flashlight (LED side).
When the flashlight is turned on, it will go to low as the default mode.
Continue to click on and off within 2 seconds after it was tumed aff to shift
between low and high brightness levels. If it is turned on over 2 seconds
after it was switched off, it will go directly to low mode as default again.
lt is normal for the flashlight not being able to reach 180 lumens when the
battery voltage is too low (under 1.0V).
lt is normal for the flashlight to blink when the battery is Funning out.
EXCLUSION CLAUSE
Olight is not liable for damages or injuries sustained resulting from the
usage of the product inconsistent with the warnings in the manual, including
but not limited to using the product inconsistent with the recommended fockout
mode.
When the light is first tumed on, it will go to low as the default mode. Soft
press without fully clicking for Momentary on. Cycle through momentary low and
high mode by quickly soft pressing, letting go, arid soft pressing again. Deep
press for constant on (you will hear a click). Continue to click on and off
within 2 seconds after it was turned off to shift between low and high
brightness levels. If it is turned on over 2 seconds after it was switched
off, it will go directly to law mode as default again.
WARRANTY
Within 30 days of purchase: Contact the original seller for repair or
replacement.
Within 5 years of purchase: Contact Olight for Fepair or replacement.
This warranty does not cover normal wear and tear, modifications, misuse,
disintegrations, negligence, accidents, improper maintenance, or repair by
anyone other than an authorized retailer or Olight itself.
USA Customer Support
cs@olightstore.com
Global Customer Support
contact@olightworld.com
Visit www.olightworld.com to see our complete
product line of portable illumination tools.
Dongguan Olight E-Commerce Technology Co., Lid.
4th Floor, Building 4, Kegu Industrial Park, No 6
Zhongnan Road, Changan Town, Dongguan City,
Guangdong, China.
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>