THERMON PN 27656 Thermostat Connection In Line Power Kit For Use With TubeTrace Bundles Instruction Manual

June 13, 2024
THERMON

THERMON PN 27656 Thermostat Connection In Line Power Kit For Use With

TubeTrace Bundles Instruction Manual

The following installation procedures are suggested guidelines for the installation of the Terminator ZT/FAK-4 and FAK 4L Thermostat Connection In- Line Power Kit.

Receiving, Storing and Handling

  1. Inspect materials for damage incurred during shipping.
  2. Report damages to the carrier for settlement.
  3. Identify parts against the packing list to ensure the proper type and quantity has been received.
  4. Store in a dry location.

Terminator ZT/FAK-4 and FAK-4L Kit Contents

FIG 1.JPG

FIG 2.JPG

FIG 3.JPG

Terminator ZT Certifications/Approvals

IP66 -60°C ≤ Ta ≤ +50°C T5, 100°C; -60°C ≤ Ta ≤ +40°C T6, 85°C Ordinary & Hazardous Locations

FIG 4.JPG

Dimensions

FIG 5.JPG

Required: Order Separately for each heater to be fabricated.
PETK Power and End Termination Kits (one req’d. per heater)

Tools Required

FIG 7 Tools Required.JPG

The Terminator ZT/FAK-4 and FAK-4L Thermostat In-Line Power Kit is designed to provide accurate control with the ZT thermostat and make a waterproof seal over the end of TubeTrace and terminate Thermon electric heat trace in an approved Terminator junction box. Review Instructions prior to installation. Kit will make one connection.

Installation Precautions

  • Keep ends of bundles, heat tracing and kit components dry before and during installation.
  • To minimize the potential for arcing on electrical heat tracing caused by product damage or improper installation, use appropriate ground-fault circuit protection.
  • Installation must comply with Thermon requirements and be installed in accordance with any applicable national and local codes.
  • Component approvals and performance ratings are based on the use of Thermon specified parts only. User supplied power connection fittings must be listed or certified for intended use.
  • De-energize all power sources before opening enclosure.
  • Individuals installing these products are responsible for complying with all applicable safety and health guidelines. Proper personal protective equipment, or PPE, should be
    utilized during installation. Contact Thermon if you have any additional questions.

INSTALLATION PROCEDURES

FIG 8.JPG

FIG 9.JPG

FIG 10.JPG

FIG 11.JPG

FIG 12.JPG

FIG 13.JPG

FIG 14.JPG

European Headquarters: Boezemweg 25 • PO Box 205 • 2640 AE Pijnacker • The Netherlands • Phone: +31 (0) 15-36 15 370
For the Thermon office nearest you visit us at . . . www.thermon.com

© Thermon, Inc. • Printed in U.S.A. • Information subject to change.

Read More About This Manual & Download PDF:

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

THERMON User Manuals

Related Manuals