RALPH LAUREN IG RL5341NBPWCG Hailee Medium Sculpted Chandelier Instruction Manual
- June 4, 2024
- ralph lauren
Table of Contents
RALPH LAUREN IG RL5341NBPWCG Hailee Medium Sculpted Chandelier
Instruction Manual
ASSEMBLY INSTRUCTIONS
Hailee Medium Sculpted Chandelier
Item # RL 5341
NOTICE:
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
-
Carefully remove all parts from the box.
-
Remove the mounting plate (B) from the canopy (F) by loosening side screws (E).
-
Put the mounting plate (B) on the ceiling and mark the holes position with pencil.
-
Drill 4 holes on the ceiling and knock the anchors (L) into the holes.
-
Install the mounting plate (B) to the outlet box and secure with mounting screws (C), then secure the wood screws (M) to the anchors (L) and lock tight.
-
Connect the fixture ground (bare) wire with the ground wire from the outlet box using wire nut (A) .If your house does not have ground wire,n then attach this wire to the green grounding screw inside of the outlet box. IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
-
Connect the fixture Neutral (ribbed,no markings) wire with the neutral wire from the outlet box using wire nut (A).
-
Connect the fixture Hot (smooth edge,markings) wire with the hot wire from the outlet box using wire nut (A). DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR
SAFETY WILL BE COMPROMISED. -
Tuck these wire connections neatly into the outlet box to secure.
-
Attach canopy (F) to the mounting plate (B) and secure with side screws (E).
ASSEMBLY INSTRUCTIONS
Hailee Medium Sculpted Chandelier
Item # RL 5341
NOTICE
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
- Assembly the metal ring (H) to the canopy (F) by using rods (G) and securing with nuts (D) (See fig 1).
- Assembly the metal ring (K) to the metal ring (H) by using rods (I) and securing with `nuts (D) (See fig 1).
- When attaching the hanging hooks to the metal ring (H and K), follow locations for hooks at (fig 2 and fig 3).
NOTE: To further secure the hanging hooks, place a drop of loctite on the top thread, then firmly tighten the nuts (J).
- Hang the crystal (from 1 to 5, total 5 kinds, 88pcs) to the hanging hooks, no specific location, just put it on the desired hanging hooks.
- Insert bulbs (not included) into the sockets.
- Installation is complete, turn on power at fuse or circuit breaker.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>