SHAPE Window Well Covers Instruction Manual
- June 13, 2024
- SHAPE
Table of Contents
Spring Clip Hardware
Installation Instructions
What You Need
Tension Spring Clips
3/16″ Bolts
3/16″ Cap Nuts
VIDEO INSTRUCTIONS
Installation
1. Place the window well cover over the window well and push it tight against the exterior of the house. (FIGURE A)
FIGURE A
2. Center the cover on your well and mark the locations where the clips will attach. (FIGURE B)
FIGURE B
3. Remove the cover from your well and drill a 3/16″ hole at each marked location. (FIGURE C)
FIGURE C
4. Mount the clips to your cover using the provided cap nuts and bolts provided and tighten the screw until you’ve reached your desired tension. (FIGURE D)
FIGURE D
5. Snap the window well cover onto the rim of the window well. (FIGURE E)
FIGURE E
Cleaning Instructions
Clean your window well cover with a mild solution detergent and water. Use of harsh chemicals or solvents may damage plastic and void warranty.
For warranty information, visit our website
www.shapeproducts.com | 5205 Freitag Drive Menomonie, WI 54751 | Phone: 715-232-0495 | Email: info@shapeproducts.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>