BURSON H0594509 LED Crystal Outdoor Exterior Wall Sconce Instruction Manual
- June 13, 2024
- BURSON
Table of Contents
BURSON H0594509 LED Crystal Outdoor Exterior Wall Sconce
ASSEMBLY AND INSTALLATION INSTRUCTIONS
WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE
NOTES:
- Before installing, consult local electrical codes for wiring and grounding requirements.
- READ AND SAVE THESE INSTRUCTIONS.
-
Attach the mounting plate to the outlet box by using two mounting screws.
-
Set the crystal glass into the upper lamp holder, and then use two screws through the opening of the rectangular bracket with the crystal to fix on the panel, and tighten.
-
Pull out the wires and grounding wire from the outlet box. Make wire connections using the wire nuts, as follow:
—Connect the hot wire(usually black insulation)from the fixture to the black wire from the power source.
—Connect the neutral wire(usually white insulation)from the fixture to the white wire from the power source.
—Attach the fixture grounding wire(usually green insulation or bare wire)to the mounting strap with the green grounding screw. Then connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box. -
Insert the mounting plate into the back plate, align the two dental grain holes of the mounting plate with the back plate hole, and then fix it with two screws.
CAUTION: With silicone caulking compound, caulk completely around where the back plate meets with the wall surface to prevent water from seeping into the outlet box.
Tum on the power at fuse or circuit box.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>