SHCK RACK The Hooks A 2 In 1 Surfboard Storage Solution Instruction Manual
- June 13, 2024
- SHCK RACK
Table of Contents
”The Hooks”
INSTRUCTION MANUAL
PARTS INCLUDED
RECOMMENDED TOOLS
RECOMMENDATIONS
Mounting to wood: Pre-drill the wood 30 mm deep with a 2.5 mm wood drill
bit. Use included screws to drill into the wood. No need to use the included
plugs.
Mounting to structurally stable brick or concrete: Pre-drill the wall 30
mm deep with a 5 mm concrete drill bit. Install included plugs and use the
screws to drill into the plugs.
BAMBOO CARE
This product is intended for indoor use only. Using it outside and exposing it
to elements such as water harms the bamboo and can result in irreparable
damage.
Same goes for storing your surf equipment while it is not fully dry. Be aware
that this can result in both visual and structural damage to the product.
If you do want to protect the product from the elements we recommend coating
the bamboo with a varnish. Always consult an expert when working with these
materials.
DISCLAIMER
We designed this product for a specific use and it is not to be used for
purposes not matching those stated in the product’s promotional materials.
When customers are installing and/or using the product, the product
(installation) instructions should always be followed. Customers ought to be
rightfully skilled to install the product, and are expected to have knowledge
on the placement material/wall composition. If not so, customers are expected
to ask help from someone knowledgeable on these matters. After installation,
customers are expected to always inspect and test the product before use.
SHCK RACK disclaims all liability for any personal injury or losses caused by
the (improper) installation or usage of the product, as well as any liability
for damages to personal belongings or surroundings caused by the (mis)use of
the product.
- Measure the size of your board. We advise to hang the board on 1/5 – 3/5 – 1/5. (With a board that’s 200 cm this would mean the hooks are 120 cm from each other.)
- Decide on what height you want your board from the floor. The distance from the screw holes is approx. 35 cm. For example, if you want the bottom of the board to be 150 cm from the floor, you’ll have to add 35 cm. (185 cm)
-
- Place a wallblock against the wall and use a water level. Mark dots on the wall with a pencil on the correct height.
- Make holes of 30 mm with a power drill and put the plugs in the wall.
- Tape the foam on the hook. Start at the tip of the hook and work towards the top. Cut of the remaining foam
- Attach the three wall blocks, with the logo print on the ront, to the wall with the screws. Afterwards, click the hook into the attached wall piece.
- Follow these same steps for the second hook. Now it’s ready to be used for your board and wetsuits.
- After seeing your hard work we’d appreciate it if you could leave us a review (don’t forget to include a picture) and tag us @shckrack
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>