hygger HG066 Dual-Core Frequency Conversion Heater User Manual
- June 13, 2024
- hygger
Table of Contents
hygger HG066 Dual-Core Frequency Conversion Heater
hygger’s aquarium heater is designed specifically for freshwater aquariums and is an excellent choice to maintain a stable water temperature.
Attention
- Place the hygger heater fully submersible as illustrated in the diagram below.
- Unplug the heater and wait for 15 minutes before changing the water or removing the heater.
- Please make sure there is enough water flow and circulation in the fish tank when using the heater.
- Reminder: The controller is not waterproof, please do not expose it to water.
PRODUCT PARAMETERS
Model No:| | HG066|
---|---|---|---
Power| 600W| 800W| 1000W
Voltage| | 110V/60Hz|
Cord length| 5.9ft+3.9ft| 5.9ft+3.9ft| 5.9ft+3.9ft
Application| 60-120Gal| 120-180Gal| 180- 240Gal
Temp Accuracy| ±0.1°F| ±0.1°F| ±0.1° F
Control Range| 59°F~93°F| 59°F~93°F| 59°F~93°F
PACKAGE INCLUDES
- 1 x Heater with controller
- 4x Suction cups
- 2x Sucker holders
- 1 x User manual
USER INSTRUCTION
Step 1: Ensure the heater is fully submerged before plugging it into an
electrical socket.
Step 2: Upon powering on, the screen will display several parameters
including the current power, current temperature, setting temperature, low,
hi, and auto shut off. To set the desired temperature, press the “red” button
on the controller. The temperature can be set from a low of 59 degrees
Fahrenheit to a high of 93 degrees Fahrenheit. If the button
is pressed again at the highest temperature, it will return to the lowest
temperature to cycle. After setting the desired temperature, the setting
temperature will jump 3 times before the heater enters the heating state.
Step 3: Please note that if the water temperature falls below 59 degrees
Fahrenheit, the code “LL” will be displayed, with “Low” flashing, indicating
that the water temperature is too low and needs to be increased to the
appropriate temperature. Conversely, if the water temperature exceeds 93
degrees Fahrenheit, the code “HH” will be displayed, with “Hi” flashing,
indicating that the water temperature is too high and needs to be lowered.
WARNING: To guard against injury, basic safety precautions should be observed including the following:
- Read and follow this user manual strictly.
- DANGER- To avoid possible electric shock, special care should be taken since water is employed in the use of aquarium equipment. For each of the following situations, do not attempt to repair yourself; return the heater to an authorized service facility for service or discard the heater.
- If the heater shows any sign of abnormal working, unplug the power and remove the heater from the water 15 minutes later.
- Carefully examine the heater after installation. It should not be plugged in if there is water on parts not intended to be wet.
- Do not operate the heater if it has a damaged cord or plug if it is malfunctioning, or if it is dropped or damaged in any manner. The power cord of this heater cannot be replaced, if the cord is damaged, the heater should be discarded.
- To avoid the possibility of the heater plug getting wet, position the aquarium stand and tank to one side of a wall-mounted receptacle to prevent water from dripping onto the receptacle or plug. A “drip loop”, shown in the figure below, should be arranged by the user for each cord connecting the heater to the receptacle. The “drip loop” is the part of the cord below the level of the receptacle, or the connector. If an extension cord is used, to prevent water traveling along the cord and coming in contact with the receptacle. If the plug or receptacle does get wet, DO NOT unplug the cord. Disconnect the fuse to the circuit breaker that supplies power to the heater. Then unplug and examine for the presence of water in the receptacle.
- Close supervision is necessary when the heater is used near children.
- This heater is not allowed to be used by persons(including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the heater by a person responsible for their safety.
- To avoid injury, do not contact moving parts hot parts, and so on.
- Always unplug the heater from the outlet when not in use, before putting on or taking off parts, and before maintenance or placing hands in the water. Never yank the cord to pull the plug from the outlet. Grasp the plug and pull to disconnect.
- Do not use the heater for other than intended use. The use of attachments not recommended or sold by the appliance manufacturer may cause an unsafe condition.
- Do not install or store the heater where it will be exposed to the weather or to temperatures below freezing.
- Only use in freshwater or saltwater, do not use the heater in other liquids.
- Close supervision is necessary when the heater is used near children.
- This heater is not allowed to be used by persons(including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the heater by a person responsible for their safety.
- To avoid injury, do not contact moving parts or hot parts, and so on.
- Always unplug the heater from the outlet when not in use, before putting on or taking off parts, and before maintenance or placing hands in the water. Never yank the cord to pull the plug from the outlet. Grasp the plug and pull to disconnect.
- Do not use the heater for other than intended use. The use of attachments not recommended or sold by the appliance manufacturer may cause an unsafe condition.
- Do not install or store the heater where it will be exposed to the weather or to temperatures below freezing.
- Only use in freshwater or saltwater, do not use the heater in other liquids.
- Read and observe all the important notices on the heater.
- If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for fewer amperes or watts than the heater rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.
- Read and observe all the important notices on the heater.
- If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for fewer amperes or watts than the heater rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.
- The 2-conductor power cord has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use an extension cord unless the plug can be fully inserted. Do not attempt to defeat this safety feature.
- The heater is intended FOR HOUSEHOLD USE ONLY. SAVE THIS USER MANUAL.
TROUBLESHOOTING
ATTENTION
- Please check all the items to inspect the condition when unboxing the package.
- Please read the instructions carefully. Use and follow the instructions strictly.
- Please choose a suitable size for the aquarium.
- Please place the oval heater in the way of water flow and don’t bury it.
- Please place the oval heater submersible fully when it’s on duty, unplug the oval heater, and wait for 15 minutes before changing water or removing over heater.
- Please mind that the oval heater can be turned off automatically when exposed to air, but it is the last resort.
DISPOSAL
Do not dispose of this product as unsorted municipal waste. Collection of such
waste separately for special treatment is necessary. This product must not be
disposed of together with the domestic waste. This product has to be disposed
of at an authorized place for recycling of electrical and electronic
appliances. By collecting and recycling waste, you help save natural resources
and make sure the product is disposed of in an environmentally friendly and
healthy way.
ONE-YEAR LIMITED WARRANTY
This product MUST be purchased from an authorized hygge reseller. Visit our website for a list of unauthorized resellers. hygger warrants this product against defects in materials and workmanship for ONE(1) YEAR from the date of the original retail purchase and is non-transferable. Warranty on all products, including aquariums. However, it is limited to the replacement of the products and does not cover fish loss, personal injury, property loss, or direct, incidental, or consequential damage caused by using this product.
Note: hygger One-year Limited Warranty does not cover damage caused by
the following: improper installation, saltwater corrosion, electrical surges,
or modifications. If you discover a defect, please contact Hygger, who will,
at its option, repair or replace the product at no charge, provided that you
return it during the warranty period. A copy of the bill of sale is required
as proof of the original purchase date in the event of the product needing
repairs within the warranty period. hygger does not warrant any products that
are not hygger’s. This warranty does not apply if the product has been damaged
by accident, abuse, misuse, or misapplication, or modified without the written
permission of Hygger.
Website: www.hygger-online.com
E-mail: Mago@hygger-online.com
Thank you for choosing Hygger, making aquarium keeping easier one product at a time. If you have any problems or suggestions for the Hygger dual-core frequency conversion heater, please contact us by email before leaving feedback or opening a case, it will be the fastest way to solve your problem. If you are satisfied with the Hygger dual-core frequency conversion heater, please leave positive feedback for our product, in order to let more customers enjoy it. Thanks again!
CONTACT INFORMATION
Company Name: Shenzhen Mago Trading Co., Ltd
Add: Bantian Group Business Center, Longgang District, Shenzhen City,
Guangdong Province, China
Website: www.hygger-online.com
E-mail: Mago@hygger-online.com
If you have any problem, please provide your invoice and shipping address by
E-mail: mago@hygger-online.com.
Company: E-CrossStu GmbH
Address: Mainzer Landstr.69,60329
Frankfurt am Main
E-mail: e-crossstu@outlook.com
Tel: +49 69332967674
GET Product Service Ltd.
Beacon House Stokenchurch Business Park,lbstone Rd, Stokenchurch
High Wycombe HP14 3FE UK
info.cetservice@gmail.com
+447419325266
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>