dacor DRT304S Slide-In Gas Rangetops Installation Guide
- June 13, 2024
- dacor
Table of Contents
dacor DRT304S Slide-In Gas Rangetops
WARNING
- Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information.
- This appliance must be installed in accordance with the accompanying installation instructions.
Product Dimensions
RANGETOP WIDTH (A)
DRT304S| 29 7/8” (75.9 cm)
DRT366S| 35 7/8” (91.1 cm)
Electrical and Gas Supply Requirements
ELECTRIC CIRCUIT REQUIREMENTS
Circuit Required| Total Connected Load
120 Vac 60Hz, 15 Amp. (3 wire)| 1.0 Amp @ 120 Vac, 60 Hz.
**GAS SUPPLY PRESSURE REQUIREMENTS***
Gas Type| Manifold Pressure| Minimum Gas Supply Pressure
Natural Gas| 5” Water Column| 6” Water Column
Propane (LP)| 10” Water Column| 11” Water Column
- Maximum gas supply pressure for all models is 1/2 p.s.i.
Cabinet and Countertop Layout
Installation of a non-combustible material* (up to the hood) or a backsplash is always recommended, and mandatory if the distance to the back wall from the rangetop is less than 2 1/2” (Figure 2). When installing a backguard, use only Dacor model number AEB3609.
CABINET/COUNTERTOP DIMENSIONS -ISO VIEW
- Vertical to combustible surface from cooktop grate level; if installing an overhead vent hood, also check the hood specifications for minimum required clearances.
- See Cabinet/Countertop Dimensions – Top View
- Not applicable for cabinets more than a horizontal distance of 10” (25.4 cm) from the edge of the rangetop.
| Model No. | B | C |
|---|---|---|
| DRT304S | 30” (76.2 cm) | 30” (76.2 cm)* |
36” (91.4 cm)**
DRT366S| 36” (91.4 cm)| 36” (91.4 cm)*
42” (106.7 cm)**
- Minimum ** Recommended
Cutout tolerances: +1/16” (+1.6 mm), -0, unless otherwise stated
| Model No. | B – Cutout Width | D | E |
|---|---|---|---|
| DRT304S | 30” (76.2 cm) | 13 3/8” (34.0 cm) | 10 1/8” (25.7 cm) |
| DRT366S | 36” (91.4 cm) | 16 5/8” (42.2 cm) | 11 3/16” (28.4 cm) |
NOTE: Gas and electrical connections may only be routed through the bottom of the rangetop when installed with a downdraft vent.
| Model No. | B – Cutout Width | D | E | F – Vent Cutout |
|---|
DRT304S
with ERV3015*
| 30”
(76.2 cm)
| 13 3/8”
(34.0 cm)
| 10 1/8”
(25.7 cm)
| 27 1/2” (69.9
cm)
DRT366S
with ERV3615*
| 36”
(91.4 cm)
| 16 5/8”
(42.2 cm)
| 11 3/16”
(28.4 cm)
| 33 1/2”
(85.1 cm)
- Use only downdraft vent model specified. Downdraft vent is not compatible with DRT rangetops having a serial number starting with letters “SA.”
- www.dacor.com
- Phone: 800-793-0093
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>